2003 Oldsmobile Silhouette Logo
Posted on Mar 08, 2017

Front Wiper Issues

I am having a problem with my 2003 Silhouette's wipers. The wipers when I turned them on dragged across the window very slowly, and went down very slowly. Then, they wouldn't go back up, then finally went up and down again in the same pattern. As they went across the windshield a 3rd time they just stopped completely. Finally, they went back down. My husband looked things over and checked for power to all the prongs in the plug that attaches to the motor, that was fine. He figured it must be the motor, so we replaced it. It is still acting that way. We tried to make sure they were in proper aligment after installing..but they are still not working. The underside of the wiper transmission looks like where it attaches to the part of the motor where the fine teeth are almost looks like it is more smooth than has grooves to line up with the grooves on the part of the motor it attaches to. Could the transmission be the problem or are we looking at a different problem?

  • Anonymous Jan 08, 2009

    I have had the same problem. I took to dealer as I was under extended warranty. They repaired. Several months later, driver side wiper stopped entirely. They repaired again. Now passenger side wiper going beyond edge of windshield and now inoperable. Taking to get fixed again tomorrow.

    Oh brother!!!! I'm ready to trade in.

×

4 Related Answers

Anonymous

  • 373 Answers
  • Posted on Feb 03, 2009

SOURCE: wiper arms dont move

there are little teeth on the connection if they are worn then you need to find out hoe to replce them

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 16, 2009

SOURCE: Replacing the rear wiper motor on a 2002 olds silhouette

I have the same issue, and just did it yesterday.

1. remove the rear hatch door handle with a T35 star screwdriver bit
2. gently pry the panel up exposing the two bottom plastic push fasteners
3. I used a flat prybar with the notch on the fastener and pryed both off
(the push fastener has 2 washers on the top end so get the pry bar under the top one)
4. Now pull the panel off the side door latches and gently pull down again to expose the two back push fasteners and pry them off too.

You now should be able to remove the motor. The wiring harness comes off easily after you figured out that the only the small end closest to the wires comes off, not the whole "box". Insert the small blade of a jacknife crosswise in the space on top of the connector and pry up the tab letting the fasterner slip off.

I found a motor on the net for about $80 (part number1880686) but it currently is out of stock so I have to wait a couple of weeks to finish. I put the panel back on without the push fasteners and will wait the 2 weeks. Buick dealer wanted $320.

Good Luck

Jim
517-784-5385

Anonymous

  • 2317 Answers
  • Posted on Mar 06, 2010

SOURCE: rear window wiper works for a few days or weeks

Check the plug is completely plugged into the motor. Maybe a bad connection in the motor itself. Also check the switch, try wiggling it when turning on.

GM Elec

Bruce Bracey

  • 1000 Answers
  • Posted on Mar 15, 2010

SOURCE: my 2003 oldsmobile silhouette front wiper blades

You can replace the nut with a locking style nut. Your local hardware store should be able to provide you with one.
You can also purchace a small tube of "lock-tight" (brand name) that you apply to the threads then tighten the nut. Once the lock tight has dried, the nut will not come loose.
Good luck.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2007 Chevy equinox windshield wiper fluid goes to the back window when I push the front windshield wiper, but



"If the windshield wiper fluid of your Chevy Equinox ends up on the rear window instead of the windshield, there could be several possible causes:

Damaged or incorrectly connected windshield wiper fluid tube: The tube that carries the windshield wiper fluid from the reservoir to the base of the front windshield wiper may be damaged or not connected properly, causing the fluid to leak elsewhere.

Clogged windshield wiper fluid outlet: The outlet of the windshield wiper fluid on the base of the front windshield wiper may be clogged with dirt or debris, causing the fluid to flow onto another part of the car, such as the rear window.

Windshield wiper system issues: There may be a problem with the windshield wiper system of your Chevy Equinox that causes the fluid to leak onto other parts of the car instead of the windshield."

0helpful
2answers

Where can we buy replacement blades online?

Amazon.com: Silhouette Replacement Blade

www.amazon.com > ... > Replacement Blades
Amazon.com, Inc.This replacement blade is compatible with all Silhouette electronic cutting tools. .... center" from Silhouette online store) It has taken me 3 blades to get through ...
Windshield Wiper Blades - Advance Auto Partsshop.advanceautoparts.com/c3/windshield-wiper-blades/15566462 results - Save on Windshield Wiper Blades with great deals at Advance Auto Parts. Buy online, pick up in-store in 30 minutes. ... Replacement Parts (460).Wiper Blade (Windshield) at AutoZone.com - Best Wiper ...www.autozone.com/ignition-tune.../wiper-blade-windshieldAutoZoneReplacement Parts ... Vehicle Specific Bosch Evolution/Wiper Blade (Windshield).Price: $15.19. Part Number: 4820; Application: Front; Notes: Beam Design
1helpful
1answer

Olds Silhouette Passenger Side wiper not working

Your wipers have a transmission of its own. It is located between the wiper motor and the wiper arms. the linkage to the right wiper arm has fallen off. More than likely you will need to replace the transmission. If the wiper motor is original, replace it at the same time. Sometimes you can buy the two together. Any other questions, feel free to write back, good luck.
0helpful
1answer

My 2003 oldsmobile silhouette front wiper blades have stoped working several times. The screw that holds the wiper arm to the motor keeps coming loose. Is there anything that will help. We have replaced...

You can replace the nut with a locking style nut. Your local hardware store should be able to provide you with one.
You can also purchace a small tube of "lock-tight" (brand name) that you apply to the threads then tighten the nut. Once the lock tight has dried, the nut will not come loose.
Good luck.
0helpful
1answer

Rear window wiper works for a few days or weeks

Check the plug is completely plugged into the motor. Maybe a bad connection in the motor itself. Also check the switch, try wiggling it when turning on.
0helpful
1answer

1999 oldsmobile silhouette passanger side wiper flew off the van

I had the same problem with my 99 Silhouette...after they put in a new windshield wiper kept going over the side of the window and tearing the blades up....ended up that the wiper arm was out of adjustment ....they came back and readjusted and it was perfect
0helpful
1answer

Wiper Motor Problem!

this is not a fix but might keep you alive if you get stuck in the rain again. try Rain X you wipe it on your windshelid then wipe it off. water just slides off and fast. I have used the stuff for ten years now.
0helpful
1answer

My front wipers stand straight up when turned off,is it the wiper motor or something else?

Its just the wiper motor if your using your wiper and you want to turn off the wiper wait until the wiper go back to its original position then turn off the wiper as fast as you can so it will not stand out when you turn it off or you can replace the motor of the wiper.

I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482

42helpful
6answers

2001 Pontiac montanaThe front wipers park in the up position

This is a common problem with Chevy Venture, Olds Silhouette, and  Pontiac Montana. The mechanical wiper drive and parking cam assembly, if it's not broken, needs adjustment. The spring loaded stop arm should engage the vertical tab on the assembly mounting plate when the wiper motor reverses. See pic.  9a7b0af.jpg
I will upload the instructions to fix this problem, if there is interest.
0helpful
1answer

2003 Oldsmobile Silhouette - Rear Wiper not working

This sounds like the wiper motor has failed. It is a common problem that usually starts with the wipers moving slower than normal, then eventually quits all together.
Not finding what you are looking for?

79 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...