You may need to replace the PCM, engine computer. very rare issue. Personally, I would leave it. It is only there to tell you if a cylinder is not firing. You will know if one is.
HD41 CHECK CMP SENSOR OUTPUT
- Connect PCM.
- Connect digital multimeter.
- Start engine and vary engine RPM.
- Measure voltage between CMP and PWR GND circuits at the PCM harness connector.
Does AC voltage vary greater than 0.1 volt AC?
Yes
No
VERIFY the correct installation by referring to the Electronic Engine Controls, Section 303-14 in the Workshop Manual. If CMP is installed properly, REPLACE PCM (refer to
Section 2 , Flash EEPROM).
REPLACE CMP sensor. COMPLETE Misfire Monitor Repair Verification Drive Cycle.
----------------------------------------------------------------------------------------------
P1309 - Misfire Monitor Disabled
When the misfire monitor is disabled, usually due to the input signal generated by the camshaft position (CMP) sensor, by sensing the passage of teeth from the CMP wheel.
- Camshaft position sensor
- Powertrain control module
- ECT, MAF, and CKP sensors
Verify the CMP is installed correctly and not out of synchronization.
×