1999 Acura CL Logo

Related Topics:

Posted on Sep 18, 2010

Where is the egr valve on a 99 acura cl - 1999 Acura CL

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 3 Answers
  • Posted on Nov 28, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 28, 2010
Answers
3
Questions
0
Helped
1382
Points
5

Right side under front park plug wires at curv
you might have a plastic cover to remove first
the EGR is located on the end of the head on transmishion side
has plug on top and 2 nuts holding it on

4 Related Answers

Anonymous

  • 11 Answers
  • Posted on Dec 21, 2008

SOURCE: 97 acura cl, 4 cyl

Hi
If they checked and that is your problem don't clean it change it pay once now and you will not have to pay to clean it and after 2-4 months you will need a new one.
HTH.
Zues

Ad

Anonymous

  • 140 Answers
  • Posted on Dec 30, 2008

SOURCE: Can the EGR valve on a 1997 Acura CL 2.2 be cleaned?

Sometimes you can remove them and clean the carbon build up off of them and lubricate it before you reinstall it. Make sure you can find a new gasket before you take it off. Usually you ruin the gasket removing the EGR. Good luck. Please rate me so I know how I'm doing. Thanks.

Anonymous

  • 299 Answers
  • Posted on Sep 23, 2009

SOURCE: What is the location of the EGR Valve?

it is located right next to the the intake manifold on the trans side of the car

Anonymous

  • 1 Answer
  • Posted on Dec 11, 2009

SOURCE: I replaced EGR valve on my 97 Acura 3.0 CL after

Good news, the EGR valve for the 97 Acura was recalled. If your car is under 150,00 miles you should be eligible to get it fixed for free. I had the same problem with my 97 Acura CL 3.0. After changing the EGR valve, I found out that the vavle itself was not the problem, but rather a blocked intake manifold. Talk your local Acura dealer.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

99 acura code p1491

Code P1491 in Honda/Acura vehicles means insufficient EGR valve lift. Note - this is not the same as 0401 for EGR low flow when you have to clean EGR passage in the intake manifold. If code 1491 is not accompanied with 0401 - that could be faulty EGR valve itself. Try to reset the code, and if it will return soon - replace EGR valve. If, however you see both codes together - cleane the manifold passage before you replacing the valve.
2helpful
1answer

Engine ligth p0401 egr valve insuf. I replaced it light still on

check the two vent that the valve hooks up to are not clogged or restricted they usually plug up with carbon
0helpful
1answer

What is the location of the EGR Valve?

it is located right next to the the intake manifold on the trans side of the car
8helpful
4answers

I replaced EGR valve on my 97 Acura 3.0 CL after

I am fixing to change my EGR valve and the piece of paper that came with the part say this:

Important Notice
Before installing this part, check the EGR valve passage in the intake manifold and clear any carbon blockage. Failure to do so will result in repeat malfuntion of the EGR valve system. Refer to a technical service manual or contact a service dealer for proper cleaning procedures.

Hope this helps.
0helpful
1answer

Started with a EGR valve OEM code, cleaned and put it back in, that code is gone. Now having misfire codes on cylinders 1 and 2. Replaced the spark plugs and wires. Could it still be the EGR valve?

Yes it Still Can be the EGR valve Replace it i found one For About 69.00 OEM they normally run for 89-120. Replace it just cleaning it is not enough they go bad especially if its original. and they tend to read same codes when its bad.Hope this Helps.
1helpful
1answer

Car wont start

try unbollting the EGR valve and see if it is blocked try starting the car with it slightly unbolted and pulled away from the engine if it runs then the EGR is blocked remove it and clean it out!
1helpful
1answer

97 ACURA 3.O L STALLS ALL THE TIME

Could be the ignition switch, if the green key light is flashing then the issue is the switch. There was a recall issued for the ignition switch for this car back in 03 for the 97 to 99 Acura CL.
2helpful
1answer

Can the EGR valve on a 1997 Acura CL 2.2 be cleaned?

Sometimes you can remove them and clean the carbon build up off of them and lubricate it before you reinstall it. Make sure you can find a new gasket before you take it off. Usually you ruin the gasket removing the EGR. Good luck. Please rate me so I know how I'm doing. Thanks.
0helpful
1answer

97 acura cl, 4 cyl egr valve cleaning, mechanic checked, cleaning or replacement

Hi
If they checked and that is your problem don't clean it change it pay once now and you will not have to pay to clean it and after 2-4 months you will need a new one.
HTH.
Zues
Not finding what you are looking for?

793 views

Ask a Question

Usually answered in minutes!

Top Acura Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...