1994 Jeep Cherokee Country Logo

Related Topics:

Posted on Sep 18, 2010

My dash lights and my radio stop workin when i was installing a new radio, how can i fix this?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 8 Answers
  • Posted on Sep 18, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Sep 18, 2010
Answers
8
Questions
1
Helped
4257
Points
27

Sounds like you have a problem with the power supply. Check the fuse. if ok, remove the new radio and check the power connection to the radio. if you cut into a wire harnis to find a hot 12v connection, you may have severed the dash 12v supply or knocked it loose . Take it slow and retrace your steps, but first check the fuse panel. You may have shorted out a wire without knowing it when attempting the install. lift the pos. lead on you battery the next time you play with 12v.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Dash lights not workin on my 96 jeep

check dimmer rheostat switch and could be faulty headlight switch
all lights out at same time prob not bulbs
0helpful
1answer

Dash lights dont shut off after installing a new radio can someone help me?

installed new radio n now my dash lights stay on even when key isnt in the ignition.
0helpful
1answer

Radio

if youve replaced all fuses and radio not working the impact could have losened conections to radio. pull radio and check conections/leads if ok have radio checked out
0helpful
1answer

TURN SIGNAL LIGHTS NOT WORKINING. I CHECKED THE FUSE, BUT ITS GOOD. THE BULBS ARE GOOD AS WELL. THEY BOTH WENT OUT AT THE SAME TIME. WHAT DO I DO?

Hello alex 10299
Try a new flasher. The flasher is located in the power distribution ctr. under the radio behind the center of the dash. Hope this is helpful.
0helpful
1answer

Installed a new radio now I don't have inside dash lights

Your old radio had at least 2 power wires, some had 3. One of them stays hot all the time for the clock and radio presets, the second is hot when the key is turned on. And the third is hot when your dash lights are on. If you get these mixed up when replacing the radio, you will have this problem. Most of the dash lights on a GM are under the taillight fuse. I would check them all with a test light. Make sure you are not powering your radio from this circuit. You don't want to dim your radio.
2helpful
1answer

I just replaced my radio and now my dash lightsare not workin do u no where i went wrong

check your fuse for the instrument lights youmay have blown it when intsalling new radio. if it is blown replace with same amp fuse if it blows again pull out the radio and see if you left a wire bare
0helpful
2answers

Power to raido will not change from am to fm no dash lights trans shifts hard.

try unplugging the transmission range selector on the side of the trans and see if yur radio works properly after that,i know this sounds weird but give it a shot,i have seen these switches keep radios and windows from workin on taurus's and windstars,hope this helps
0helpful
1answer

DASH LIGHTS GO ON AND OFF

I had the same issue with my wife's 01 beetle and it ended up being a bad alternator.
1helpful
1answer

New radio installed - now dash lights don't work

Most factory stereos are wired to the dash dimmer switch. Usually if the dash lights go out after an after market stereo installation, it is because the wire that originally went to the factory stereo is not used for after market stereos. Double check the fuses and ensure the wire that controlled the lights on the factory stereo is not grounding out on something.
0helpful
1answer

Powerlocks

i shoul not afect any thing unless you replace the batterie with the car runing, and some radios have antitheft code if batterie die or disconect the radio will ask you to type a code in order to work again but most of times it display the worl code on the digital screen
Not finding what you are looking for?

119 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...