-
Mercury Master
2,993 Answers
- Posted on Sep 15, 2010
Re: How do I replace the ac/heater blower moter?
Hope this helps....please don't forget to rate...thank you:
Removal & Installation
-
Before servicing the vehicle, refer to the Precautions section.
-
Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
-
Disengage the wire harness connectors from the retainer.
-
Disconnect the blower motor electrical connector.
-
Remove the motor cooling hose.
-
Remove the screws and remove the blower motor.
NOTE
Prior to removing a wheel that is to be reused, clean any corrosion from the blower motor shaft to prevent damage to the wheel mounting shaft.
-
Remove the wheel from the blower motor as follows:
-
Remove the push clip.
-
Remove the wheel from the blower motor.
Blower motor cooling hose
Blower motor mounting plate
To install:
-
Install or connect the following:
-
Wheel to the blower motor, if removed.
-
Blower motor and securely tighten the screws.
-
Motor cooling hose
-
Blower motor electrical connector
-
Wire harness retainers
×