-
GMC Master
17,989 Answers
- Posted on Sep 07, 2010
Re: How do you remove a starter on a 1997 GMC Jimmy?
1995-97 4.3L MODELS and 1995-99 2.2L models
Fig. 5: The starter motor on later model 4.3L engines is retained by two long bolts
-
Disconnect the negative battery cable.
-
Raise and support the front of the truck safely using jackstands.
-
If necessary for access, disconnect the front exhaust pipe.
-
If equipped, remove the starter heat shield.
-
On the 2.2L engine, remove the brace rod from the front of the engine and the bell housing.
-
On 2.2L engines, remove the drivers side wheel to access the
starter motor wires and the starter motor attaching bracket-to-engine
bolt through the opening in the wheel well.
-
Disengage the wires from the starter solenoid.
-
On the 2.2L engine, remove the attaching bracket-to-engine mount bolt.
-
Remove the starter-to-engine block bolts. When removing the last
bolt, be sure to support the starter to keep it from falling and
possibly injuring you.
-
Carefully lower the starter and shims (if equipped) from the vehicle.
-
If necessary, remove the bracket (2.2L engine) or the shield (4.3L engine) from the starter assembly.
To install:
-
If removed, install the bracket or shield to the starter, as
applicable. Tighten the bracket nuts to 97 inch lbs. (11 Nm) or the
shield nuts to 106 inch lbs. (12 Nm).
-
Carefully raise the starter and shims (if equipped) into position
in the vehicle and thread one of the retaining bolts to hold it in
position.
-
On the 2.2L engine, loosely install the bracket-to-engine mount bolt.
-
Install the remaining starter mounting bolt, then tighten all mounting fasteners to 32 ft. lbs. (43 Nm).
-
Engage the wiring to the solenoid as noted during removal.
-
On the 2.2L engine, install the brace rod and tighten the retainers.
-
If disconnected for access, install the front exhaust pipe and tighten the fasteners.
-
If equipped, install the starter heat shield.
-
On 2.2L engines, install the drivers side wheel.
-
Remove the jackstands and carefully lower the truck.
-
Connect the negative battery cable.
Hope helps.
×