- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The oil pump is located just inside the oil pan if you remove your oil pan you'll be able to see the oil pump sending unit. The oil pressure gauge switch is located just above the oil pan on the engine block beneath tge cylinder head. Hope this helps.
V6 ENGINE OIL PRESSURE SENDING UNIT LOCATION NEXT TO OIL FILTER. THE 4 CYLINDER ENGINE OIL PRESSURE SENDING UNIT LOCATION IS FRONT CAMSHAFT HOUSING ON THE LEFT DRIVER SIDE OF THE ENGINE COMPARTMENT.
On 4 cylinder engines: The oil pressure sending unit is located in the rear of the block near the oil filter housing
On 6 cylinder engines: Sending unit is located near the oil filter housing behind the air conditioning compressor, on the front side of the block
The oil sending unit is located on the engine block behind the drivers cylinder head area.You have to climb up on the motor to see it cause it is hard to see behind the wiring harness.You may also want to purchase a new sending unit because it is very long and you might need to buy the sending unit socket to replace it.Hope this helps.Good luck.
The oil pressure sending unit is located to the right of the oil filter and just above the starter motor. This is on the 3.4 liter V6.
On the 2.4 liter 4 cylinder the switch is on the left (drivers) side of the cylinder head.
per the Haynes manual for the 95-05 Dodge Stratus on the 2.0L & 2.4L DOHC 4 cyl engines, the oil pressure sending unit is located at the left end of the rear side of the block. On 2.4L SOHC 4 cyl engines, the sending unit is located at the left end of the rear side of the block. On 2.5L & 3.0L V6 engines, the sending unit is located on the oil filter housing, on the front side of the block. On 2.7L V6 engines, the sending unit is located at the left end of the rear side of the block. To access it, remove the heat shield.
×