At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yes - Sometimes when the battery is replaced the key program can be corrupted. It would be a starting point to have the key reprogrammed just to eliminate it as a source of trouble.
I have to ask this question. Have you changed the battery? if the battery is good have you tried any other remotes. If one remote works and the other does not. The remote is probably bad. If all remotes do not work then the cars ecu for the door control could be bad or as simple as a fuse.
Likely problem? It sounds like you have a pinched power wire somewhere, cutting off power to the remote control receiver when the door is closed, I'd have the dealership check it out.
You lost your program of the key module follow these instructions.
To Program a Remote for a VW
Put your good key in the ignition and turn to "ON", do not start the engine. Make sure all the remotes you want to use are present because they have to be programmed at the same time. - Close the door and insert key #2 into the driver's side lock. Lock the door. -Within 5 seconds of locking the door, press unlock 2 times on the new remote, key #2. -(if this is remote #3, press unlock 3 times. if this is remote #4, press unlock 4 times). -If there's a chirp or beep do not press it again. This means that the car has recognized the new keyless entry remote. - Repeat with other remote or unlock the car and turn off - done.
JAGUAR XJ8 Remote Control Programming
1. Unlock the Boot/trunk with key.
2. Turn Ignition on.
3. Warning light on dash comes on.
4. When they go out, lift arm rest, inside their is a valley button, Press 5 times within 5 secs of lights on dash going out, Horn & Lights Flash.
5. Press any button on remote, remote programmed.
Before you spend bigger amount, check the battery in the key. Usually a CR2032 battery can be find there. (Open the Keyfob by inserting an object into the key ring holder and pulling the top and bottom apart, Seperate the two halfs, Open the top half to expose the battery... )
×