My brake lights do not work on my 1996 accord.

its the brake light switch....have it changed and if that does not solve the issue, check the ground wire to the brake light

Check your fuses

theres a sensor behind brake pedal may be stuck or faulty

The brake light switch is located at the break peddle..........To test you have to remove and do a resistance check.When the button on the switch is in you shouldn't get any restance but with the button out as if the brakes were applied you should...........Hope this helps you out.

Definitely sounds like a fuse. Keep your bulbs from the original lights. A blown fuse is black, and usually has the resistor blown to pieces and rattling around inside the plastic casing =) Good Luck!

if the abs light came on then you have a bearing problem if the wheels not turning then its bad there are so many thing that go wrong its hard to tell with out the car here to look at

The light means you are low on fluid now. If your rear brakes are not working you have a master cylinder or proportioning valve problem. You may also have a leak at the rear.

It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

check that the master cylinder is not locking on with a pressure build up the cyl may need replacing probly does

http://wiki.answers.com/Q/How_do_you_change_the_high_mount_center_brake_light_bulb_in_a_1996_Honda_Accord