SOURCE: My service air bag light
First you got to check the conections to the module otherwise contact :http://www.myairbags.com/ or http://www.airbagsystems.com/index.html
SOURCE: 99 jeep grand no power lock or windows on passengers
check the wires that run from the door to the body near the hinges. they always break inside that rubber boot.
SOURCE: How do you reset an air bag light in a 1996 Pontiac Grand Am SE?
The airbag light staying on could be an indication that the abs computer ( located under passenger front seat ). may have gotten wet. These cars usually let water in from the front strut towers. The light staying on indicates a problem with the computer, possible things that could happed:
a: air bag DOES not deploy in an accident.
b: air bag does deploy for no reason whatsoever.
either of those could be bad.
best to have it inspected by a certified abs tech or the dealer
SOURCE: air bag light flashing
the most common cause of the airbag light is a defective rotoating ribbon contact under the steering wheel that connects the airbag to the steering column wiring harness, the contact is called the clock-spring contact.
SOURCE: 330I drivers side airbag deployed and the car will not start
You triggered the impact sensor.(usually on or near the front bumper) It will need to be re-set or replaced, and obviously, you need to replace airbag.
Fig. Passenger air bag module view
Disarming the Airbag System
What i have is the steps on how to put or replace the heater core. hope this will help you.
the core is located behind the steering column, meaning you mainly need to remove that. On more recent cars, the whole dashboard needs removal.
Older Models
Shut off power to the Maxima, especially the air bag system. Disconnect the negative battery terminal and wait at least 3 minutes for the air bag to lose energy.
rain the engine coolant from the cooling system. Use a clean container if you plan on reusing the coolant.
Disconnect the heater hoses from the heater unit inside the engine compartment. Remove the blower and cooling unit from the interior and then the steering member assembly. Remove the heater unit and the core from the unit.
Install the new core into the heater unit and reconnect the unit in the car. Connect the steering member, cooling unit and heater hoses.Refill the cooling system and connect the battery cable.
Newer Models
Unplug the negative battery terminal. Wait 3 minutes for the air bag system to lose power. Drain the engine coolant into a clean container.
Disengage the air bags from both sides of the car. Remove driver's bag by removing the steering wheel's lower and side lids and the Torx bolts from the wheel sides. Disconnect the passenger bag electrical connector from inside the glove box.
Disassemble the instrument panel. Remove all components and screws from the panel, then have an assistant help lift and remove the panel itself.
Disconnect the following heater, defroster and ventilation ducts on the rear and sides. Remove the heater housing and the heater core from the housing.
Reinstall the heater housing with the new core installed. Replace all ducts, the instrument panel and the air bags.
fill the cooling system and reconnect the battery cable. Let the Maxima
117 views
Usually answered in minutes!
×