My personal suggestion would be to go for these repair catalogs from www.reliable-store.com instead. much better info on all vehicles, complete details, and
they also have live assistance feature
SOURCE: lincoln ls year 2000 v8 3.9litres
The traction control gets its information from the ABS system, so a faulty sensor reading will automatically shut down the traction control system.
It is common in this vehicle for the sensor to malfunction!
Brake system warning
Momentarily illuminates when the
ignition is turned to the START
position. Also illuminates if the
parking brake is engaged. If the
brake warning lamp does not
illuminate at these times, seek service immediately. Illumination after
releasing the parking brake indicates low brake fluid level and the brake
system should be inspected immediately.
Anti-lock brake system (ABS)
Momentarily illuminates when the
ignition is turned to the ON
position. If the light remains on,
continues to flash or fails to
illuminate, have the system serviced
immediately. With the ABS light on, the anti-lock brake system is
disabled and normal braking is still effective unless the brake warning
light also remains illuminated with the parking brake released.
Here is a link to your free owners manual with an explanation of all the lights and features of your car as well...
http://safemanuals.com/user-guide-instructions-owner-manual/LINCOLN/TOWN%20CAR%202000-_E
Click on the PDF user guide on the right side.
SOURCE: Parking Brake Light on Lincoln LS Problem
there is a sensor in your mastercylinder that senses brake fluid level it is probably low.check your brake pads they could be close to needing replaced.
SOURCE: 2004 lincoln ls 3.0 abs light and traction control
have the car scanned with a scanner capable of reading ABS codes,get back to me with the code and we'll go from there. sounds like like one of the wheel sensors is bad. this controls both ABS and TRACTION CONTROL
SOURCE: 2004 Lincoln LS A/C Valve
In order to charge, you must locate the low pressure valve to install the refrigerant. The low pressure valve is between the compressor and the evaporator. Do not charge on the High Pressure side, The high pressure valve is between the compressor and the condenser. To locate the low pressure valve, follow the line that comes from the compressor and routes toward the firewall. The valve will be somewhere on that line. Do not overcharge. The amount of pressure that is needed on the low pressure side will depend on the ambient outside temperature.
SOURCE: 2002 lincoln ls
my 2002 lincoln ls wont go in drive or except the gas when i give it gas like the pedal is all the way to the floor and it still wont budge any suggestions?
229 views
Usually answered in minutes!
×