2002 Buick LeSabre Logo
Posted on Aug 13, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

How to take off the water punp - 2002 Buick LeSabre

Answer This Question

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Genius:

An expert who has answered 1,000 questions.

  • Master 1,035 Answers
  • Posted on Aug 13, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Genius:

An expert who has answered 1,000 questions.

Joined: Mar 26, 2010
Answers
1035
Questions
0
Helped
400151
Points
3026

1. Drain the cooling system until the coolant is below the level of the water pump. 2. Remove the drive belt guard. 3. Loosen the water pump pulley bolts. 4. Remove the drive belt. 5. Remove the water pump pulley bolts. 6. Remove the water pump pulley. 7. Remove the water pump bolts. 8. Remove the water pump. 9. Remove the water pump gasket. 10. Clean the water pump mating surfaces. Installation Procedure 1. Install the water pump gasket. 2. Install the water pump Notice: Refer to Fastener Notice in Service Precautions. 3. Install the water pump bolts. Tighten the bolts to 10 Nm (89 inch lbs.). 4. Install the water pump pulley. 5. Install the water pump pulley bolts. 6. Install the drive belt. Tighten the water pump pulley bolts to 25 Nm (18 inch lbs.). 7. Install the drive belt guard. 8. Fill the cooling system

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the water pump on a 95' Chrysler lebaron
If 3lt v6 engine, the water punp is inside the timing cover and run off the timing belt
Read full answer
Jul 10, 2015 • Chrysler Cars & Trucks
1helpful
1answer

Water leaking from front of oil pan
Very likely coming from the weep hole in the water pump, and dribbling down front of engine.
The weep hole is usually on the hidden side (back) of water punp and not easily seen. follow the trickle.
When water pump begins to leak like that, it means the bearing are wearing, and the seal is giving out as consequense. It will steadliy get worse. Verify the source of leak and replace the water pump if indicated..
Read full answer
Jul 12, 2011 • 1992 Jeep Cherokee Sport
0helpful
1answer

If you change the thermostat in your curris and still no heat, does that mean you need to replace the water punp?
no the water pump is probably fine unles it is leaking. You may need a new heater core.
Read full answer
Mar 13, 2011 • 1999 Chrysler Cirrus
0helpful
1answer

Water punp making a lot of noise
Have your water pump inspected by your repair shop. If the water pump is noisy it needs to be replaced asap. The bearings in the pump become loose and can break apart, which can be costly in the future.
Read full answer
Feb 19, 2011 • 2005 Dodge Caravan
1helpful
1answer

Water punp is linking
if the pump is leaking from around the gasket then gasket needs replaced but if the leak is coming from the bottomout of a weep hole then the barring is bad and water pump needs replaced this is a very comm in chev water pumps
Read full answer
Feb 07, 2011 • 2004 Chevrolet Silverado 2500HD
0helpful
1answer

I need a diagram of the 1998 plymonth voyager engine so I can replace the water punp
I suggest that you visit the autozone.com website and register the car. It doesn't cost anything and will give you access to an online repair manual for the car. The steps for replacing the water pump can be found there. Hope this helped and best wishes.
Read full answer
Sep 06, 2009 • 1998 Plymouth Voyager
0helpful
1answer

1996 dodge caravan 2.4 the water punp was replace and when the motor was on it star shaking do you think is aout of time.
Could be, as timing belt needs to be removed to do water pump.
Read full answer
Jul 18, 2009 • 1996 Dodge Caravan
3helpful
1answer

Water punp location
Located behind front engine plate. This u don't want to do it is driven by the timing belt which has to be removed and allso upper mount has to be removed.U also have to remove the pulley that u need a special puller for.
Read full answer
Jun 28, 2009 • 1996 Chrysler Sebring
0helpful
1answer

Water punp
Chilton's repair manual at your local part supplier
Read full answer
Dec 03, 2008 • 1996 Ford Thunderbird LX
0helpful
1answer

1993 ford ranger
transmission put d en the motor turn on off
Read full answer
Jun 15, 2008 • 1993 Ford Ranger SuperCab
Not finding what you are looking for?

View Most Popular

2002 LeSabre

  • Cars & Trucks

Related Question

Where is the water pump on a 95' Chrysler lebaron

  • Chrysler Cars & Trucks

Related Topics

950 views

Ask a Question

Usually answered in minutes!

Popular Questions

Buick forum

Buick LeSabre Cars & Trucks

Buick LeSabre Limited headlight switch

2000 Buick LeSabre

P0171 Code (Lean Fuel Bank 1) Engine light on

1998 Buick LeSabre

1995 Buick LeSabre Custom Serpentine Belt installation

1995 Buick LeSabre

1995 Buick LeSabre - horn blows

1995 Buick LeSabre

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...