Question about 1989 Toyota Camry

1 Answer

How to replace ignaction cylander - 1989 Toyota Camry

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 327 Answers

Hello, Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota.

  1. Disconnect the negative battery cable. If equipped with an air bag, wait at least 90 seconds before working on the vehicle.
CAUTION: Some models covered by this guide may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in .
  1. Remove the lower steering column cover. Unfasten the ignition switch connector under the instrument panel.
  2. Remove the screws which secure the upper and lower halves of the steering column cover.
  3. Turn the lock cylinder to the ACC position with the ignition key.
  4. Push the lock cylinder stop in with a small, round object (cotter pin, punch, etc.).
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
  1. Withdraw the lock cylinder from the lock housing while depressing the stop tab.
  2. To remove the ignition switch, unfasten its securing screws and withdraw the switch from the lock housing.
TO INSTALL:
  1. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.
  2. Secure the switch with its screw(s).
  3. Make sure both the lock cylinder and column lock are in the ACC position. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.
  4. Install the steering column covers.
  5. Connect the ignition switch wiring.
  6. Connect the negative battery cable.
Thanks

Posted on Aug 12, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 volvo 850 missfire cylander 4


If this has the coil over the spark plug try replacing the coil. If it still has wires replace the cap, rotor and wires. Do a compression test and check for a mechanical problem like a burnt valve.

May 08, 2014 | 1996 Volvo 850

1 Answer

No compression on one cylander 1998 sonata


what about the plug and wire for that cylinder?

Mar 30, 2014 | Hyundai Motor 1998 Sonata

1 Answer

Spark plug order for 1997 honda accord lx and distributor cap


i you have a 4 cylander it is 1,3,4,2.
if you have a 6 cylander it is142536.

May 01, 2010 | 1997 Honda Accord

1 Answer

#4 cylander is misfiriing where is the # 4 cylander located on a 2002 Ford escape 6cyl. 4x4


Middle cylinder on firewall side of engine. Front is 1-3-5, firewall side is 2-4-6 from front of engine.

Apr 25, 2010 | 2001 Ford Escape

1 Answer

I NEED TO POP THE TRUNK AS THE KEY CYLANDER IS HANGING INSIDE THE TRUNK


You can crowl thou the back set area and remove the lach cach it will take a 10mm socket and rachet. then you can reset the cylander.

Jul 14, 2009 | Honda Civic Coupe

1 Answer

Rear exaust manafold won't move and line up with cylander head.


Are there studs or bolts on the front cylinder head? If there are bolts then secure the rear manifold first.Or replace the rear studs with bolts.

May 16, 2009 | 1999 Ford Taurus

1 Answer

92 saturn sl1 shifts hard


go to www.saturnfans.com

Mar 22, 2009 | 1993 Saturn SL1

Not finding what you are looking for?
1989 Toyota Camry Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...