Fuel Pump - Removal & Installation
To install:
WARNING
If the modular fuel sender assembly is retained by a snapring, it
may spring up from its position. When removing the modular fuel sender
from the tank, be aware that the reservoir bucket is full of fuel. It
must be tipped slightly during removal to avoid damage to the float.
Fuel sender assembly
External fuel strainer
Connector retainer from the wiring harness and the fuel pump
Fuel pump electrical connection by lifting the cover assembly
Baffle and pump assembly from the retainer by rotating the fuel pump baffle counterclockwise
Fuel pump outlet by sliding it out of slot
Fuel pump outlet seal
Fig. Exploded view of the fuel sender assembly mounting to the tank
Fig. Exploded view of the fuel pump assembly
NOTE
Gently pull on the fuel pump reservoir to assure it is secure. If not secure, replace the entire fuel sender.
Fuel pump outlet with a new seal by sliding it in the reservoir cover slots
Fuel pump and baffle assembly onto the reservoir retainer by rotating it clockwise until seated
Lower retainer assembly partially into the reservoir by aligning
all 3 sleeve tabs and pressing the retainer onto the reservoir making
sure all 3 tabs are firmly seated
Connector retainer to the wiring harness and the fuel pump
External fuel strainer
Snapring, if equipped to the retainer slots while holding the
modular fuel sender assembly down or use Fuel Sender Lock Nut Tool
J-39765 in order to install the cam lock ring
Fuel tank
Negative battery cable
Hope helps (remember rated and comment this).
The fuel pump in your vehicle is located in the fuel tank. you need to lower the tank down to access it. good luck!
Inside the fuel tank
To install:
Pull the fuel pump down so that it is tight against the bracket.
751 views
Usually answered in minutes!
×