What's wrong with my car? You looking for a magical fix ? There are none ! Testing using electric test equipment an check the fuel pressure an flow with the proper tools , also hooking up an obd1 scan tool an checking sensor data . Are you familiar with obd1 ? Electronic fuel injection an all the sensors involved ? mass air flow , crankshaft postion , Cam position , MAP sensor , engine coolant temp. sensors , Ignition control module . Any one of these being bad could be the cause . Are you willing to replace all of these till you fix it . Do yourself a favor an take your vehicle to a qualified repair shop , because without testing all you'll get here is guessing without testing .
SOURCE: stalling problems
Hi
There can be many reasons for stalling.There can be dust obstructed in the carburetor thus the idling system is not working properly.There can be a leakage in the air pipe system and may be the pcv valve got damaged or the secondary accelerator may stuck open or the tick over or mixture not well adjusted.or the air filter may be clogged .So try my friend and it will be ok.
SOURCE: check engine light on, car shakes while in reverse, stalls ...
You need a code scanner hooked up to find out what is causing the light ot come on. Some auto part stores can do that. Once the code is retrieved, they can tell you what sensor is causing it.
SOURCE: 94 v6 camaro automatic.. no reverse or neutral.
Sounds like you may have burned out the reverse clutch pack inside the transmission by going from drive to reverse. I would recommend seeing a transmission shop for verification. Hope this helps
SOURCE: The engine in my 96 saturn wagon shakes when it is put into gear, reverse or drive.
remove the belt and spin all of the pulleys by hand to make sure they all spin freely. the knocking noise is probebly a pulley locked up.
122 views
Usually answered in minutes!
×