P0344 what code is that - 2005 Dodge Dakota

open link and follow diagnostics toward repairs https://www.obd-codes.com/p0344

That code P0344 doesn't mean to replace the cam sensor . It means you do the diagnstic's for that code . Could be a wiring issue , or the computer could be bad . Your best bet ,take it to a qualified repair shop .

clearing codes wont correct the problem and limp mode is designed to protect motor and transmission - p0700 is a transmission problem
P0700 Transmission Control System Malfunction p0340 is camshaft position sensor malfunction
https://www.obd-codes.com/p0340 p0344 is also a camshaft position sensor circuit problem
P0344 Camshaft Position Sensor Circuit Intermittent your p430 is a cat converter problem
https://www.obd-codes.com/p0430 and p0888 is transmission relay problem these reasons are limp mode the knock can be fuel not burning correctly or a lower engine knock can mean you damaged a piston

p0128- coolant thermostat
p063a-
p0344-camshaft position sensor A bank 1 -circuit intermittent
p0480- engine coolant blower motor 1- circuit malfunction

Hi Ricky, I'm glad to help. Below is the possible causes for the P0344 code that you have.



Symptom:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
When Monitored and Set Condition:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT

When Monitored: Engine running or Cranking.
Set Condition: When the failure counter reaches 20. One Trip Fault.
POSSIBLE CAUSES

GOOD TRIP EQUAL TO ZERO
WIRING HARNESS INSPECTION
(K7) 5 VOLT SUPPLY CIRCUIT OPEN OR SHORTED TO GROUND
TONE WHEEL/PULSE RING INSPECTION
CHECKING CKP SIGNAL WITH THE DRBIII
t LAB
CAMSHAFT POSITION SENSOR
(K44) CMP SIGNAL CIRCUIT OPEN
(K44) CMP SIGNAL CIRCUIT SHORT TO GROUND
(K44) CMP SIGNAL CIRCUIT SHORTED TO B+
(K44) CMP SIGNAL CIRCUIT SHORT TO (K7) 5 VOLTS
PCM

Hello Anonymous,maybe you can read this PDF ,it can help you,
Diagnostic Trouble Code Table .

That code is for a knock sensor. You said you replace the camshaft sensor.

These are camshaft position sensor codes. Replace camshaft sensor.

P0441 is Evap Emission control system incorrect purge flow.

P0344 is Camshaft position sensor.

P0344 will deff cause your hesitation issues.

this is an eng code p0344 CAMSHAFT SENSOR need to replace this will give you long start or no start