When you start the motor the engine check light keep on not going off. How to reset

Once the problem that caused the engine light to come on is repaired the light will go off. Resetting it without a repair will not keep it off.

Whats the code that keeps coming back? Is it possible that is is as simple as something is not plugged in?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Go to your local O'Rielly's or Autozone. They will tell you the code and reset it for free. Otherwise take the negative battery cable loose for about 10 min. This will clear the ECM, but you won't know what tripped the light! Best Wishes, TJ

the racing you hear is most likely a slipping in the transmission. in terms you may understand is this,you're giving the car gas,but the gas does'nt work,you hear the engine roaring,but slow motion?if this is the case,you may need a transmission fluid filter and fluid change,this may help.depending on how long the problems been going on. 3.0 engines are really good motors.but the transmissions behind the engine demand clean fluid,filter. is your check engine light on? the hard shift tells me somethings wrong already.you may only have a bad speed sensor. suggest you move towards the speed sensor. if the chck engn lghts on. do what i described above. if not,no light on,suggest you reset your computer by disconnecting the positive cable from your battery for 10minutes.this will reset the whole system and keep in mind that any existing problems will keep arising. good luck and thank you for choosing fixya.com

the check engine can be reset by disconnection of the NEGATIVE battery cable for 5 minutes or ask a local Kragen or Autozone parts store to reset the light, they will do this for free as well as read the fualt code that is stored in the memory of the engine/emission system control computer whenever the light is turned on, just tell them you would like a OBD2 fault code test, PLEASE.

The service engine light is the check engine light. Different name for the same thing.

Replace the coolant sensor on the front of the intake manifold.The coolant sensors on this engine does go bad and wont set a check engine light. The sensor will read about -32 to 0 degrees when they do go bad. The computer thinks it is that cold and sends tons of fuel to the engine. If you try to start the engine with the throttle depressed to the floor it puts the fuel system in clear flood mode and wont fire the injectors. Engine will start then and run very rich. The coolant sensor has two wires on it and sometimes you need to replace the wiring pigtail going to it as the sensor can seep coolant into the connector and corrode the terminals. All the parts are available at pepboys and autozone or napa. Good luck

usaly You use a OBD 2 Scan tool if you do not have one you might want to disconect battery for a minute then reconect the battery how ever keep in mind if you do not fix the switch that cause the *eng light* to come on it will return when you start the car up again,Hope this helps ,John

Just disconnect the battery (negative terminal) and turn the headlight switch on for about 15 minutes. This should reset the PCM. Otherwise go to Advance and have them hookup the code reader and reset the codes. Thanks

TURN THE IGNITION KEY TO RUN WITH THE ENGINE OFF.FULLY PRESS AND RELEASE THE ACCELERATOR PEDAL THREE TIMES WITH IN FIVE SECONDS.YOU HAVE TO DO THIS MORE THAN ONE TIME.ITS NOT GOING TO RESET FIRST TRY BUT DO THIS PROCEDURE.UNTIL THE CHANGE ENGINE OIL LIGHT WILL FLASH WHILE THE SYSTEM IS RESETTING.TURN THE KEY TO OFF.WAIT A FEW SECONDS.START CAR UP TO SEE IF CHANGE OIL LIGHT COME BACK ON.IF YES YOU HAVE TO TRY THE RESET PROCEDURE AGAIN.