My 1998 mitsubishi eclipse 2.0 non-turbo stopped run running, i noticed that it keeps burning the ENGINE fuse located in the engine compatment fuse box. I've replaced the fuse but everytime i turn the key switch it burns the fuse. I disconnected the fuel pump and the same problem occures.
You have an electrical short to ground on that circuit , do you know how to test automotive electrical circuits using a DVOM - digital volt ohm meter ? How to read a wiring diagram , so you know which circuits to test ?
What fuse ? number an amp
SOURCE: How to remove crankcase pulley from 1998 Mitsubishi Eclipse.
Its just one bolt in the center. there is usually i panel in the wheel well that you can take off to get to it real easy. I always use a repair manual from autozone. it tells you what to do step by step.
SOURCE: need the vacuum hose diagram for a 1998 mitsubishi eclipse
http://www.dsmtuners.com/forums/attachments/420a-bolt-tech/89827d1228187918-resolved-need-vacuum-line-help-fast-420aturbovac-boostlinesstock.jpg
hope this helps
SOURCE: how do i replace the radiator in a 1998 mitsubishi
Hi,
Drain engine coolant
Disconnect radiator upper and lower hoses from radiator
Disconnect transmission cooler hoses (if automatic)
Remove overflow hose from radiator neck
Set coolant jug and bracket aside
Remove two 12mm bolts holding upper insulators on
Unplug electrical connectors for cooling fans
Lift radiator up out of vehicle.
Alternately, you can unbolt the two cooling fans from the radiator and leave them in. They are held on with four 10mm bolts. It is easier to leave the fans installed for a first timer though
SOURCE: 1998 mitsubishi eclipse GS 2.0 non turbo automatic,
Have you changed the spark plugs and fuel filter yet?
SOURCE: how do i reset my timing gears on my 1998 mitsubishi eclipse 2.0
this link is to a step-by-step guide for installing the timing belt. 2.0L NT TIMING BELT diy
if your car is the 2.4L non-turbo let me know and i'll post up the procedure for that motor.
170 views
Usually answered in minutes!
×