Need to know where ignition coil D is located on a 2005 lincoln LS 3.0 v6?

B+ voltage at the coil pack ? Test crank sensor signal to PCM , videos on youtube ! What engine ? 3.0 l or 3.9 l ? Coil on plug ignition ? Check fuse F1.12 10amp located in the Under hood AUX junction box . Autolite Coil on Plug Ignition troubleshooting

Todd, Low side A/C port, Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

2000 Lincoln LS AC Low pressure port Location
2005 Lincoln ls low pressure port
low side port 2003 lincoln ls v6 Google Search

under a plasrtic cover in the midle of valve cover

The spark plugs in the v6 can become an involved job as the upper intake manifold. The LS uses a Coil on Plug (COP) ignition system, meaning that the spark plugs are located under the ignition coil

Lincoln LS

V6
1,2,3 pass side
4,5,6, friver side


V8
1,2,3,4
5,6,7,8

#1 is at front closest to radiator

No need to replace an entire throttle body because of a
TACM code or ETC Fail Safe

You need to replace only (1) COP Ignition Coil that is bad
enough to cause your cars problem

It has not been diagnosed properly & I assume at a very expensive
cost to you so far

You could install one coil yourself at $38.00 on the internet,if you
knew how ,15min job.

If the bad coil is on the pass side of engine, then the upper intake
has to come off to get to the coils

Next vehicle,buy a V8

CHT-Cylinder Heat Temperature Sensor

V6--Driver Side--between COP Coil 5 & 6

V8-work in progress & I own one

NO CTS Sensor,odd I know

The message means the electric park brake needs serviced. In this case I feel that considering the ac problem, the Coolant Control Valve is defective. The valve can create RF interference that messes with the electronics of the park brake system. The Coolant Control Valve is located at the right side bottom of the radiator fan shroud and has 3 heater hoses connected to it.

It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.