2005 yukon side mirror controls do not respond. Blinker lights in the mirrors still work. ideas?

Check alldatadiy.com for wiring schematics.

http://www.bing.com/videos/search?q=replace+blinker+light+on+side+mirror+Mercedes+clk350+2008&FORM=HDRSC3

REMOVE THE MIRROR FROM THE BASE UNSCREW THE 2 TORX10 SCREWS AND REMOVE THE COVER DETACH THE BLINKER FROM THE COVER.ASSEMBLE IN OPPOSITE ORDER U REMOVED

The first thing to do is have the mirror control switch tested, remove the switch from the door panel and proble it with a 12 volt test light as you operate the different functions of the p[ower side mirrors, if that is ok then replace the mirror.

{: ) Have someone control the power fold buttons, while you check closely the passenger mirror. If you can feel or hear even a faint hum of the motor while commanded, try giving it a little help, but don't force it if you think it doesn't have enough power to extend or retract itself. The motor could be really stuck or inoperative.
Sometimes when the mirror has been accidentally or manually folded, it needs to be reset by just pressing on the fold buttons a few rounds and let the mirrors fold by itself. Like an exercise.
If you hear the humming noise whenever the fold buttons are pressed, we can assume that the circuit on that side is ok since it is responding electrically, and that a jammed or stuck mechanism is preventing it to move.
If you don't feel or hear any humming, as in totally no sign of response, then there will be additional considerations before deciding to go for a replacement mirror. You will need to confirm if the fault is on the wirings, a door module, or the mirror motor itself. A scan tool test may be recommended for effective diagnosis.
The power fold mirror can be serviced as an assembly. So, goodluck.

2003 GMC Yukon - My power mirrors stopped working.... all fuses have been checked and they are all good. Any ideas? These are the power folding mirrors. The function that allows you to fold them in for car washes etc still works.... they just will not adjust when you change drivers, or when you try to adjust them with the controls. Any ideas would be appreciated!

yea sounds like a loss of power. start by checking all! all the fuses.

Dear ejustin

Unfortunately you have too release the door panel to carry out this simple replacement.
remove screw from behind small panel inside door release handle (small screwdriver ti flip out little cover)

Remove two screws from inside door puller (one you use to close door) these are also under a small panel you remove this also with small screwdriver.

Then you will have to pull door penal away from the fixings usually done with a special tool but is quite poss-able with fingers.

Do not use a screwdriver you will just cause damage and break fixing clips.

Take care as their are wires feeding other equipment you do not need to remove panel completely.

Release cable to mirror

Remove three nuts holding mirror to door these are behind plastic quarter panel.

Repeat process to put on new mirror 20 minutes max.

Cheers

Frazer

try a glass place or take back to dealer to get the correct adhesive for the indicator