How do you adjust the camber on front end of 98 dodge caravan

Sounds like dirty Trans filter resulting in low charge pressure. Also bad modulation valve function and possible bad governor function. Replace filter first.

I don't see what year your truck is. On the newer trucks. There's adjustment cams on the lower control arms. One at the front and one at the rear mount. They adjust camber/caster.

camber is a front end alignment adjustment must have a front end machine to adjust camber

if your seeing tire wear on the outside,you will need tires rebalanced to make up for tire rubber worn away.

with packing shims were the top wish bones are bolts to chassy,,,

there is no adjustment from the factory, but a really good front end tech can make it adjustable, suggest you take it to the Toyota dealer.

You really do not want to approach this problem this way. If you suspect somthing related to aligment, get the unit put on a front end rack for inspection and adjustment. Anything less is nuts.

Doc

key is worn or wrong one if u have another dodge. if not and its the right key . its best to have a service dept look at it being the air bag is located in the center . camber : if it hasnt had shocks put on in awhile change them and have the front end realigned .

Caster +2.5 degrees to +3.5degrees Camber -.5 degree to +.5 degree but Myself for best tire wear the Camber should be set at-.2 degree to +.2 degree. as for the toe it should be set at 0 straight ahead to an 1/8 an inch toed in. I myself preferr 1/16th of an inch toed in.

bo_ronan,
Front end work can be tricky and should be done by a certified mechanic,there are a number of possibilities here,if it is a "toe out" problem this could be caused by worn tie rod ends or control arm bushings but this may also be a camber problem however camber usually affects one wheel.Camber can be caused by a bent spindle, mislocated strut tower, bent strut, worn or collapsed control arm bushing, bent control arm or a weak or broken spring. If any of these parts are replaced, camber should be checked and adjusted as needed after the parts have been installed.I hope this helps you,good luck.