How do i replace a driveshaft for a 1997 lincon cotanental

I searched under 1997 lincoln continental and found this: Driveshaft and U-Joints
REMOVAL & INSTALLATION Town Car and Mark VII-VIII Fig. 1: The bolts retaining the rear driveshaft yoke-to-differential flange require a 12mm, 12 point wrench or socket to loosen them
Fig. 2: Remove the bolts retaining the rear driveshaft yoke-to-differential flanhow do i replace a driveshaft for a 1997 lincon - 91197p11.jpgc="/uploads/images/91197p11.jpg" alt="91197p11.jpg" class="h_mi" />
Fig. 3: Sehow do i replace a driveshaft for a 1997 lincon - 91197p13.jpgriveshaft from the axle flange and . . . Fig. 4: . . . disengage the driveshaft from the transmission output shaft
Fig. 5: Insert a plug onto the splines of the transmission output shaft to prevent fluid from leaking out

1. Raise and safely support the vehicle.
2. Mark the position of the driveshaft yoke on the axle companion flange so they can be reassembled in the same way to maintain balance.
3. Remove the flange bolts and disconnect the driveshaft from the axle companion flange.
4. Allow the rear of the driveshaft to drop down slightly.
5. Pull the driveshaft and slip yoke rearward until the yoke just clears the transmission extension housing seal. Mark the position of the slip yoke in relation to the transmission output shaft, then remove the driveshaft.
6. Plug the transmission to prevent fluid leakage. To install:
   
7. Lubricate the yoke splines with suitable grease.
8. Remove the plug from the transmission and inspect the extension housing seal; replace if necessary.
9. Align the slip yoke and output shaft with the marks made at removal and install the yoke into the transmission extension housing. Be careful not to bottom the slip yoke hard against the transmission seal.
10. Rotate the axle flange, as necessary, to align the marks made during removal.
11. Install the driveshaft yoke to the axle flanhow do i replace a driveshaft for a 1997 lincon - prev.gifall the bolts and tighten to 71–95 ft. lbs. (95–130 Nm).
12. Lohow do i replace a driveshaft for a 1997 lincon - next.gifvehicle.