How do i turn off tyre puncture warning on bmw 5 series

Try to inflate each tire to the same pressure and run it. If the light comes on after clearing it, then it could be a bad wheel speed sensor circuit.

But, be warned, that the car will sense even slight pressure irregularities over several miles based on wheel speed sensor data.

Try disconnecting the battery for 2mins.

Tyre pressure warning light
Check pressures
When correct,turn ignition on and use lever on top of indicator stalk to scrool untill you see tyre pressure reset
Press end of stalk to reset

Insert key press start button,push scrool on top of indicator stalk,untill you see tyre warning. Then press end of stalk to reset

this happend to me u should just be able to reset your computer .i have and itsnot happend since

i have a bmw , 1 series, i have just put air in my tyres and there is now a warning light on the dashboard, have i over inflated my tyres?

This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.

If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.

Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.

If the light continues to come on after the reset then you definitely have a puncture somewhere!

Hope this helps!

use the I drive system to reset flat tire monitor, go to vehicle settings, then flat tire monitor, then select reset, then you have to drive the car system resets as you drive

this needs to be reset with a scan tool capable of doing european cars, call around and see if some one has this tool, get back to me if you need more help.pleaserate my fix as i strive to be te best Thanks Ray

As long as you have the correct tyre pressure , dont worry. The warning light depends on various factors