Remove passenger door panel - 1996 Nissan Pickup

Remove arm rest, door handle, pry from the panel snaps and pull up and out.

2004 Kia Optima passenger side front door panel removal YouTube

Remove interior door panels and unbolt the window mechanisms. It should be obvous once you ahve the panels off. Study online how to reove the door panels.

Remove all the screws in the door panel. Remove window and lock controls. Make sure to get the piece by the mirror on the inside. Then gently pry all the way around the panel and slowly pull it off. Once it is completely loose, lift it up and off the door.

your going to have to get that panel off with out opening the door.
remove screws ffrom door panel and try to pull up from bottom. put the passenger seat all the way back. be careful and take your time it can be done

Hi!!

Here is a blow out diagram of the door panel for your vehicle.



If you feel you need step by step instruccions with illustrations to R&R the door panel, click the following link http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c1528006f79c

Don't forget to rate this post!! Good Luck!!!

1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl

PCM Ford's Location:
* Ranger - behind instrument panel (cowl), center to both driver and passenger sides.
* Explorer/Mountaineer - behind instrument panel (cowl), (access from engine compartment dash panel) on passenger side to center of vehicle.
* All other F-Series, Expedition/Navigator - lower dash panel on passenger side.
* Excursion - lower dash panel on driver side.

The PCM is behind the glove box and has a big harness connector in the firewall that you access from the engine compartment.

REMOVAL & INSTALLATION



Fig. 1 The calibration number will be needed to order such parts as a replacement PCM, various sensors, and almost any emission control component. Typically this number is attached to a label found on the driver's door or the door pillar


1997-00 F-150, F-250, Expedition and Navigator



Fig. 2 Loosen the connector retaining bolt and remove the PCM connector



Fig. 3 Remove the passenger side front door scuff plate



Fig. 4 Remove the passenger side kick panel



Fig. 5 Remove the PCM bracket clip and remove the PCM

1. Remove the battery and the battery tray.
2. Loosen the connector retaining bolt and remove the PCM connector.
3. Remove the passenger side front door scuff plate.
4. Remove the passenger side kick panel.
5. Remove the PCM bracket clip.
6. Remove the PCM.
   

To install:

1. Installation is the reverse of removal.
2. Tighten the PCM connector retaining bolt to 36-44 inch lbs. (4-5 Nm).

Hope helps.

There is a screw behind the lock rod. Lift door panel straight up to remove

no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. then you just remove the bolts to the mirror