I have a 1995 jeep cherokee Laredo, I need to remove the alarm system, become i have problem with the alarm system.

dont just replace parts and hope--u must target the area--a data stream run w factory gear is really helpful--a code reader is usually not enough-----the module u took out is connected to ignition----inspect coil-plug wires--ignition module--distributer cap may be worn inside--look for any loose wiring in engine area----may need a fuel pressure test--regulator and pump cud be worn---basic spark and fuel hardware are the weakest links

#1 solution for this is to " BUY A GM PRODUCT" & save your money on costly repairs of these chrysler & JEEP (amc) vehicles!

The 1995 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

i have a 1997 jeep grand cherekee laredo and am having a problem with the alarm its a factory alarm it whent off and i cant get it to reset i tryed everything i could locking and unlocking the doors i put all new fuses and relays in i even unpluged top dash alarm sensor and body control module and it just dont want to reset and it dont want to run at all how can i take care of the problem

LOL !!!! To funny..

Try holding it down..
Maybe the battery is week..

They usually have these batteries at Walmart jewelry dpt..

Hope this helps !!
Rate me good ;o)

remove the fuse

If you cant start it because of the alarm disconnect the battery, wait ten secs, reconnect then turn the key in the driver's door twice holding for 2 seconds on the second turn, this should reset the alarm.

I have a 95 Grand Cherokee, its got this built-in 'kill switch' (lol) that i had to figure out - the alarm wouldn't stop going off until i put the key in the driver door, then turned it Right-Left-Right...

Your probably already aware of this nuisance, but i thought i'd post it it just in case.

i have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

There are switches on the door lock cylinders that are supposed to shut the alarm off when you use the key,but they go bad allot. you could try unlocking the passenger door first, since that one usually gets less use and is less likely to go bad. Otherwise you can disconnect the alarm module, it is located behind the glove box.