First, I'm not a Hundai mechanic.
* Check your warranty. Call Hundai for service.
*** The following is for information only***
* Replacing resistor; https://www.youtube.com/watch?v=sQblTKSiCBs
* Replacing fann; https://www.youtube.com/watch?v=MZV3mrjN-K4
* 2006 Fan switch; https://www.youtube.com/watch?v=_M8mNIo8eqc
* 2002 Sonada blower; https://www.youtube.com/watch?v=p5jToqncycw
* Resister from Auto Parts store and repair (A.D.D. challenged video);https://www.youtube.com/watch?v=XqIU5tMFTHE
Aloha, ukeboy57
SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty
I'm not 100% sure where it is, or possibly built right in to the dash control/fan switch, but I'd be tempted to stop & see the parts guy at the dealership, or another dealership, and ask if they have one, or a picture of one. Once you see it, you'll know where to look. Just a guess but quite often built right into switch on dash.
SOURCE: 03 Santa Fe blower motor resistor replacement
the part you need to replace is the blower motor resistor assembly it has a screw on each side of it with a plug in th middle and for the most part it is on the passanger under the dash behind a black cover stop by a auto store and take a look at one and then you know what you are looking for and at the same time you can find out how much its going to cost i am only going to guess it somewhere around $15.00 to 25.00 dollars.
SOURCE: Fog Light Replacement Hyundai Santa Fe
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
SOURCE: How to remove rear brake rotors
THE REAR BRAKE ROTOR IS A LOOSE ROTOR AND SHOULD COME OFF EASILY. IF NOT, IT IS POSSIBLE THAT THE ROTOR IS HELD BY RUST ONTO THE HUB OR THE BRAKE SHOES IS STILL EMBEDDED INTO THE ROTOR. REMOVE THE HANDBRAKE CABLE TO ENSURE THAT THE BRAKESHOES COLLAPSE AND TRY TO LOSEN IT AGAIN. IF SEASED ONTO THE HUB BY RUST, KNOCK THE ROTOR WITH A COPPER HAMMER TO BRAKE THE RUST WITH A RUST REMOVER.
SOURCE: How do you replace blower motor resistor on a 2004
Well you are starting in the right direction with the blower motor resistor. To change it there is only two screws that hold it to the heater case. There is also a wire harness that you need to disconnect from the blower motor also. Installation is reverse of removal.
http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
How to remove Blower
control switch?
http://howtobyme.blogspot.in/2012/02/how-to-remove-blower-control-switch-on.html
---------
Where is blower motor relay located ?
http://technoanswers.blogspot.in/2012/02/where-is-blower-motor-relay-located-on.html
--------
This will help.Thanks.
3,928 views
Usually answered in minutes!
2004 hyundai santa fe blower motor resistor location picture image
×