The abs light and the brake light wont go off after i have checked all the censors and fluid. What could be going wrong with it.

Check the break fluid level.

how much brake fluid did you remove or put brake shoes on wrong reason abs light on.check brake fluid.when replace front brakes you have make sure mastercylinder reservoir corver on then pump brake pedal seat brake shoes against rotor then check brake fluid level.

clean the abs censor and check wiring at brake end might just be **** on the censor

First of all, make sure that your brake fluid level is correct. The brake, traction, and ABS systems on these cars all work together and if one thing goes wrong in any one part of the system, all of those lights will come on at the same time. Check your brake fluid level and be sure to use the correct DOT 3 brake fluid. DO NOT SUBSTITUTE with any other fluid. Let me know if your brake fluid level is ok and we'll go from there.

ok about the abs is possible that the abs cable that goes the the brake caliper is not good.about the brake light check brake fluid level filled up also check the sensor on the brake fluid container also check any malfuntioning wire connection corosive plugs.about the ac check compressor ad freon in order to kick on check the relay or fuses or the compressor is no good

Most cars light up brake when low on brake fluid, a few cars light up ABS to show same thing. You need to scan the abs computer and get the codes, these codes will tell you whats not working then you check it out, it may be a bad wheel sensor or may just be low brake fluid but you wont be able to just shut it off. Once the problem is fixed all you have to do is drive the car down the road and the light will shut off when the computer sees everything is working correctly. Of course there is the possibility that there really is something wrong with the ABS circuit.

i would check your power steering fluid and look at your hydro booster for any leaks your power steering is what powers the brake system on your car because it does not use vacuum an when my abs light was on an trac was stuck off it was just the fuse so i would check that hope that helped you any

is it the abs light or the brake light there could be a couple different things wrong with it. if it's the abs light your abs system is acting up and it will need to be checked out. if it's the brake light then your brake fluid level sensor could be bad, or your parking brake switch could be going out, and there's other things that could be wrong with it.

When u power up the vehicle ABS does a self test(light stays on a few seconds then cuts off) and if it see's a problem will shut off and illuminate the ABS lamp. It will also do a second test on iself when you reach a speed of around 12-15 mph,it will run the pump for a few seconds to check pressure and look at the speed sensors,if it see a problem here it will again shut down and illuminate the ABS light.
Now if the red brake lamp is on then it will shut down because it thinks you have a hydraulic concern and will not try and run ABS if this is the case.
If red brake lamp is on most likely if you have good brakes it is a problem with the float sensor in the master cylinder reservior,maybe its bad or just stuck,or just low on fluid.

I'm having the exact problem! To get it in gear, turn key to unlock, put in neutral, start then in gear. That's as far as I've gotten with a solution to at least drive it. Next will check the brakes...yeah it sucks! Hope there's better advice commong...