How to fix dash pad pealing - 2000 Buick LeSabre

buy a haynes manual for that model--partstore or online----or send this issue to magicmechanic -his site has a library of auto tips but he will reply w a practical answer--hes a mastertech in any make

Have you tried bleeding the brakes? Sometimes air in the lines causes the break trouble light to come on.

I've bought dash repair kits and tried it myself several times without satisfactory results. I recently restored a trans am and had the dash repaired by a local interior shop and now I can't even tell where the cut was. It was about a 4 inch cut and they charged $50.

Sounds like a brake pad sensor light... indicating wear of brakes and that they need to be replaced...

just did my son's thunderbird, it was under dash above accelerator peal on clip hanging from dash framework, approx. 3x3 inch cubicle shape...

you must remove the cluster heres some diagrams to help you. hope this helps, dissconnect battery,then remove ash tray,remove center bezel screws,remove bezel,now remove screws for holdingdash pad behind top of center bezel, pry defrost grill out of dash unplug sensors and set aside,remove screws holding dash pad to defrorst duct and cluster,open glovebox and remove screws holding pad, remove pad,pop out has clips holding,remove screws from cluster pull cluster up and out enough to unhook connector. heres some diagram to help.

That's your brake pad wear indicator ---means you need to have your brakes checked / replaced either in the front or rear.
It's a wear sensor wire ooked to the brake pad and when the pad wear down to the wire it lights up the dash warning light.

check the brake fluid level if it is low then add

In the past I had the same problem with new pads!
You must check up if new brake pads electrical wires are OK. Try as follows:
1. Disconnect only new brake pads wires from the vehicle electrical circuit.
2. Extract old brake pads wires from old brake pads.
3. Insulation wear cap from old brake pads wires.
4. Connect old brake pads wires on the vehicle electrical circuit.
5. Switch ignition ON and start engine.
Now the wear light must go off !
Please Rate my Response! Thanks!

On my bmw 325i front pads changed,indicator on dash still on,help!!