How do I remove a fender for a 97 s10? - 1997 Chevrolet Blazer

remove the driver side front fender Teeta, Removing fender on your truck, Check the attached links,instruction and guides may be not identical but really close to yours. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
1994 to 2003 Chevy 10 GMC 15 Blazer and Jimmy Left Front Fender...
http://www.s10forum.com/forum/f137/s10-fender-removal-457021
http://www.automotiveforums.com/t561502-need_help_on_removal_of_front_fender_my_91_s10_blazer.html
S10 Fender Removal eHow

Easiest way to remove it is to take the inner fender well out and go to the blower from the bottom

They will bolt up. You may want to get the wiring plugs off the 97 t case as they will be different from yours. Or use your old t case

remove the 2 screws and access hole cover, the attena comes out of the fender access cover hole. make sure u undo the lock nut at base of attenna and i hope you have small hands lol

sorry it wont bolt up.if you have any questions jut let me know

It is in the "Fuse And Relay Center", black box on the driver side fender well, under the hood.

Yes, those fenders, etc. should be fine. Those two trucks are the same. The body didn't change until 1994 and the part numbers for the two trucks' fenders are identical all the way through 1993. Good luck! I hope this helps.

Can you remove the wheel well splash shield and get access to the bolts? Body shop techs have a special tool to get into this area.

Here's a 97 Probe whcih was the same as a 626 in 1997:

Fender, Front Removal

1. On GT models, remove the side sill extension. Refer to Section 01-08 for the removal and installation procedure.
   

1. Remove the front fender bolt located in the door jamb opening.
   
   
   RH Side Shown, LH Side Similar
   
   
   
   
   

1. Remove the three upper front fender bolts located on top of the front fender (16005) inside the engine compartment.
   

1. Raise and support the vehicle.
   

1. Remove the wheel (1007).
   

1. Remove one push pin and five front fender splash shield bolts and remove the front fender splash shield (16102).
   

1. Remove the upper front fender brace screw.
   

1. Remove the inner front fender bolt.
   

1. Remove the screw holding the front bumper cover (17D957) to the front fender.
   

1. Remove the two lower front fender bolts.
   

1. Remove the front fender.
   

Installation
To install, reverse the removal procedure. Tighten the front fender bolts to 7-9 Nm (61-86 lb-in).

no the fender stay on .just the front bumper come off