2007 toyota corolla. 6 flashes of the "maint req"

When a Honda Maint Req light blinks, but then stops, it is telling you to change your oil. If you don't change it, eventually, the maint req light will stay on. Here is how you reset the maint req light: 1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the odometer button.
4) After about 10-15 seconds, the light should go off.
If that doesn't work, try it this way: p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; font: 12.0px Verdana}

With the igniition off, press and hold the odometer button, turn the key to the "on" position, but do not start the car. Keep the odometer button down until the oil light begins and ends flashing. Turn the key off, and then start car to see if it worked or not.

try this with key off push and hold the trip re-set now turn key to on position. I have a toyota and this works for it. This may or may not work for honda

There are manufacturer recomended service/maintence requirements at
certain mileage intervals. These are programed into the cars computer.
The light is to remind you, that you have reached or close to one of these intervals. There should be a maint. schedule with the owners
manual, that describes the type of service required, at your mileage.
If you just want to turn off the light. Stop by any major parts store and
they will clear the code. Usually for free. Hope this helps.

To disable this light without unplugging the battery:

1. Start the car.
2. Place odometer on Trip A
3. Turn car off
4. Place your finger and hold the odometer trip button
5. Turn key to the "on" position while holding the trip button; not "acc"
6. Wait until the computer reset finishes
7. The maint reqd light will turn off

To reset the system. Turn the ignition key to the "OFF" position with the odometer reading shown. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold down the knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing.

Here's how you reset your oil maintenance light.

To reset the light,
Turn the ignition on
Make sure the odometer displays "ODO"
1.Turn the key off
2.Press and hold down the same button you use to get to "ODO"
3.Turn the key back to ON ( while still holding down the button)
4.Hold the button in until all the flashing lines on the odometer go away and the bunch of "000000" shows up and the maint reset light will turn off.
Your'e done.

If this doesn't work, you would have to try it on "trip A" instead of "ODO".

Hold mileage reset button down and turn key on. continue to hold button until dashes stop flashing and light goes out (approx. 10 seconds).

That is for oil changes. It come on when the oil change is due.
When you have your oil change done, the lube tech should reset the this light every time.
If you need help resetting the light, let me know.

You need to check:
A) Transsmision adjustment.
B) Transsmision mounts.
C) Motor mounts.

You can get my tip on resetting the light yourself HERE:
http://www.fixya.com/cars/r1235216-reset_procedure_maintenance_required