1994 Mercury Topaz Logo
Anonymous Posted on Jun 03, 2010

1994 Mercury Topaz Fender Removal

I have a 1994 Mercury Topaz GS 2 door, and in the past winter I slid into my wooden mailbox and dented the front drivers side fender and therefore need to remove it in order to pop the dent out... i am just not quite sure on how to remove the fender from the car? Unless you have another way of getting the small dent out of the fender without removal... thanx in advance

  • Anonymous Mar 28, 2014

    my front driver side fender on my 2008 Toyota Tacoma is dented. how do i remove it so i can pop the dents out?

×

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 2,317 Answers
  • Posted on Jun 03, 2010
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Mar 05, 2010
Answers
2317
Questions
1
Helped
788300
Points
7079

Harbor Freight and most local body shop supply stores should have a suction-cup type tool for pulling out dents. You maybe able to remove the inner fender well to get to the dent. To remove the fender, you'll need to remove the top fender bolts, the bolts that attach it to the header panel, and the bolts holding it on back by the door.

Testimonial: "Thanx i will definately try that root to save some time and money.."

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
1answer

I have a odd grinding Noise only when I'm driving this 2 door 1994 Mercury Topaz Car

check the wheel bearings for failure
check the disc rotors fir failure on the inside from brake pads worn out
0helpful
1answer

Where is the horn location under hood of a 2007 mercury mountneer?

Remove the LH front fender splash shield !
Fender Splash Shield Removal and Installation
  1. Loosen the running board bolts and lower the running board to access the front fender moulding pin-type retainer.
    • To install, tighten to 23 Nm (17 lb-ft).
  1. Remove the lower pin-type retainer from the front fender moulding.
  1. Remove the 2 rear pin-type retainers from the front fender moulding.
  1. Position the front fender moulding aside and remove the splash shield lower screw.
    >
  1. Remove the front splash shield screws.
  1. Remove the front splash shield pin-type retainers.
  1. Remove the front splash shield.
  1. Remove the front fender splash shield.
  1. To install, reverse the removal procedure.
0helpful
1answer

Removing the left front axle on a 1993 mercury topaz gs

They are held in the transmission with a snap clip. Take a small flathead screw driver and wedge it in between the axle and tranny and turn axle clock wis and counter clockwise and it will come out. When you put the new one in, you will hear it ;; snap;; in place
0helpful
1answer

How do you unhook fuel lines on fuel rell on a 1991 Mercury Topaz?

need special fuel line removal tool set for ford feul line , can buy relatively cheap at a auto parts stor (napa, pep boys, etc)
0helpful
1answer

Firing order for a 89 topaz

For the 1989 Mercury Topaz 2.3L In-Line 4-Cylinder:

Firing Order:
1-3-4-2
Cylinders:
........(back).........
|...1...2...3...4...|
........(front)
Distributor:
....(back)
(+)...4
...............2
3
........1...(+)-screw
....(front)

Let me know if this helped...
2helpful
1answer

I cannot locate my fuel pump shut off switch on my 1994 mercury topaz

I believe it should be in your passenger side kick panel next to the door
1helpful
1answer

Oil leaking in front of my engine above the oil filter. '92 mercury topaz GS, 2.3 4 cyl

possibly the oil pressure sending unit- looks like a small spark plug screwed into the engine with one wire going to it
1helpful
1answer

Need stereo wiring codes for 1992 mercury topaz

1991-92 Mercury Topaz Stereo Wiring Constant 12V+ Green/Yellow Switched 12V+ Yellow/Black Ground Red/Black Illumination n/a Dimmer Blue/Red Antenna Right Front Front Speakers 6 1/2" Doors Left Front (+) Orange/Green Left Front (-) Black/White Right Front (+) White/Green Right Front (-) Black/White Rear Speakers 6" x 9" Rear Deck Left Rear (+) Pink/Green Left Rear (-) Pink/Blue Right Rear (+) Pink/Blue Right Rear (-) Green/Orange

Robert

Please take a moment to rate this solution thanks
Not finding what you are looking for?

316 views

Ask a Question

Usually answered in minutes!

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...