Blinkers wont work.all my lights turn on flashers work just no turn signals only front side markers what can it be?

You hear a clicking sound but none os the turn signals work, neither front, rear or dash indicators? Check the underdash fuse panel to see if it is the flasher that is clicking. There needs to be some resistance in the flasher to make it work so some light should be working. Do the emergency flashers work? They use the same bulbs but a different flasher. Both systems go through the turn signal switch, Move the emergency flasher lever in and out several times to make sure there is a good connection. Check to see if current 12 volts are getting to the signal bulbs.

There should two separate bulbs for marker and blinker. It sounds like a bulb is burnt out, bad ground, melted socket or a wiring anomaly. Are you certain it's supposed to have 57 series dual element bulbs for blinker and markers?

does your car have the signal light flasher if so find it and replace it also check the fuses maybe both sides are fused separate

Could be a bad bulb ,plug, wire, or flasher; Check the side marker lights also, some are connected to the turn signal.

flasher/blinker is busted. this is located under your dash board. remove steering column cover, turn on LEFT turn signal (yes, the one that is working), then you will hear a clicking sound. locate the relay that causes the sound. there you can see 2 relays (one for LEFT, other one for RIGHT turn),replace busted one.

start your car keep in park with the emergency brake on, turn on your blinkers to right or left side, then check to see if both front and back lights and side marker lights come on if they do check the other side, you will probably fined that you have a bad bulb or two. hope this helps you.

There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

make sure our lights at rear are grounded sounds like a bad earth

ok, the dash does not show the blinker is on, did you check the front and back to see if any of the turn signals were on, but not blinking? Also the side marker lights should light up if the turn signals aren't working, do they? Let me know. Next check the fuse box, it's on the driver side, under the dashboard. The fuses will be labeled, check the fuse for the turn signals.
Check to see if it"s blown. If it is, or you aren't sure, replace it with one of the same amperage (the # of amps is on the fuse). The fuses can just be pulled out to check them. If you still don't have working blinkers, go back to the fuse block under the dash. There are 2 round canister shaped units plugged into the fuse block. One of them is the turn signal flasher. They are about the diameter of a quarter, and a bit over an inch thick. If your emergency flashers are working, unplug one of the flashers. If they don't work after unplugging one, then you just unplugged the emergency flasher, so the other one is the turn signal flasher. Replace with a new one, identical to the old one. Let me know when you have followed all these instructions and what happens. countrycurt0

Did you check the bulbs? If one bulb is burned out, the blinkers won't word on that side. You could have one bulb burned out on each side. Start the car, put left signal on. Check front and back lights. Is one light on but not blinking? If that's the case, the light that's not on at all is burned out and has broken the circuit so the good light stays on and won't blink. Check the other side. You also have a 'flasher' , actually 2. One for emergency flashers, one for the turn signals. It could be that the turn signal flasher is shot. You just have to unplug it to remove. It's probably located near the fuses. good luck countrycurt0