Transmision just stoped working in drive reverse still goes in gear graet but no drive

The linkage may be out of adjustment preventing the shifter from moving into reverse or park.
One way to test this is to disconnect the linkage and manually move the lever on the transmision making sure that it can be set into park. Also try moving the lever counting each click from park to low gear to make sure it is clicking into each gear. If this works then the linkage is probably out of adjustment.
On the link cable there is typically a bolt in an oval shaped metal near the transmission shift lever.
1)Detach the shift cable from the transmission shift lever
2)Put the transmision shift lever in the park position, and also the shifter in the cab
3)Loosen the adjustment bolt
4)Reattach the cable to the lever
5)Tighten the adjustment bolt in place
6)Confirm that you can shift through all of the gears
Hope this helps

Check with a code reader or scanner, the ABS could be at fault

if its automatic transmission check the transmision flued,level,seals might be corroded,and flued leaked out, causes lack of presure in the transmision hydrolick system,or the clutch plates inside the transmission are slipping cuase of hardening

its a transmision problem. bearing in your automatic gear shifter needs to be replaced. this is not a DYI solution.

It sounds like there is a glitch in the softwear update that was installed, It sounds to me the programed was stoped before the program was downloaded, I would call your service adviser and have them re look at this

if the forward gears are inoperative your have an internal fault and it will have to be rebuilt or replaced

it is safty in the tranny have it scan

you need a different tranny because the reverse is a direct gear and is doent engage,the reverse doest work with the drive gear system,so you have a internal mechanical problem in you tranny

Known problem with gearbox control units. High failure rate. Gearbox lights flahing. May not select reverse gear. Take to dealer as may get some goodwill on this.

http://www.2carpros.com/how_to/transmission_service_4.htm
Popular Problems Checks
1. Car will not go into gear:

• Gear selector cable has failed
• Brake lock solenoid has failed not allowing the gear selector to move out of "Park"
• Excessively low transmission fluid (note: if car is operated for an extended amount of time with low fluid level the transmission will fail prematurely)
• Shorted electrical component not allowing the PCM to control the transmission. Example: shorted fuse
• Flex plate (flywheel) is broken completely not transferring engine power to the transmission.

2. Car goes into gear but then fades out of gear or is slipping while driving:

• Transmission fluid is low
• Transmission clutch discs or bands are worn out or burned
• Faulty transmission shift solenoid.

3. Car goes into gear but does not shift out of first:

• Blown fuse to the PCM controller
• Faulty vehicle speed sensor (VSS)
• Shorted second gear control solenoid
• Faulty transmission controller (PCM)

Tips About Common Problems and Fixes