1984 Mazda RX-7 Logo
Posted on May 18, 2010

1984 RX-7 13B, When engine is cold start fine. Runs great. Upon driving 5 minutes or so. if engine is shut off engine will not start. Starter, battery cable, wires, distributor all new. To start usually jumping with another vehicale will work or just let car set a half hour and it will start.. Help

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Dec 28, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 09, 2010
Answers
1
Questions
1
Helped
155
Points
1

Check mass air flow senser

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

1984 toyota corolla 1.6 engine. How do i adjust

Carbureted models have a fast idle cam on the throttle,It is a screw that sets against a movable part,called the cam,when the engine heats up,the cam will drop upon tapping the gas pedal.Set the carb,while the engine is cold,by tapping the gas pedal,then adjust the fast idle cam screw by turning it in,with the engine running.Start out by turning the screw in a full turn before starting engine so it will run,then adjust the screw as the engine runs.
0helpful
1answer

2000 miata- from a cold start, will have multiple misfires, drive it for 5 minutes and it runs perfect. have replaced fuel filter and plugs. starts and runs perfectly the rest of the time.

how about a set of plug wires? i good way to test other than getting them wet is in the a.m. when engine cold, soak em down with some wd-40 then start if ok or greatly improved then there your culprit
0helpful
1answer
0helpful
1answer

Stalls, runs rough

your choke is sticking
0helpful
1answer

'99 chevy Silverado Z71,5.3 engine.....will not rev when hot.....

try replacing your EGR Valve, or your Oxygen Sensor
0helpful
1answer

Distributor ECM??

test the starter solenoid(or beat it lightly with a hammer), could be starter or ignition switch
0helpful
1answer

1984 bronco 2-runs 15 min shuts down wont start again for 20 runs

If the fuel filter is dirty it will settle when you turn the truck off. When it runs for a few minutes the debris in the filter will get sucked into the screen and stop the fuel from getting through. If it was a starter or coil, it would not start at all.
0helpful
2answers

Saturn SC2 Hot Start Problem

It sounds as if the crank position sensor is bad.When the engine heats up,it cases the sensor not to work.After the sensor cools it will work again.

Ken
Not finding what you are looking for?

165 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...