Removal & Installation
To install:
Accessory drive belt routing —Ford/Mercury 2.0L (VIN P) SOHC engine with A/C
Accessory drive belt routing —Ford/Mercury 2.0L (VIN P)How do I put a serpentine belt on a Ford escort - 529e408.gife without A/C
Accessory drive belt routing —Ford/Mercury 2.0L (VIN 3) DOHC engine
SOURCE: I need a diagram for serpentine belt replacement on a 1999 For Escort ZX2
the diagram is located in the engine compartment under the hood.
Clean off the surfaces and it is one of the stickers there.
SOURCE: serpentine belt installation
Normal
0
false
false
false
MicrosoftInternetExplorer4
/* Style Definitions */
table.MsoNormalTable
{mso-style-name:"Table Normal";
mso-tstyle-rowband-size:0;
mso-tstyle-colband-size:0;
mso-style-noshow:yes;
mso-style-parent:"";
mso-padding-alt:0in 5.4pt 0in 5.4pt;
mso-para-margin:0in;
mso-para-margin-bottom:.0001pt;
mso-pagination:widow-orphan;
font-size:10.0pt;
font-family:"Times New Roman";
mso-ansi-language:#0400;
mso-fareast-language:#0400;
mso-bidi-language:#0400;}
1 To replace a worn belt, locate the idler or generator
pulley.
2 Loosen the hold-down fastener for the idler or generator
pulley.
3 Pry the idler or generator pulley inward to release the
belt tension and remove the belt.
4 Match the old belt up for size with the new replacement
belt.
5 Observe the belt routing diagram in the engine
compartment.
6 Install the new belt over each of the drive pulleys. Often
the manufacturer recommends a sequence for feeding the belt around the pulleys.
7 Pry out the idler or generator pulley to put tension on
the belt.
8 Pry out the idler or generator pulley to put tension on
the belt.
9 Install the belt squarely in the grooves of each pulley.
10 Before adjusting belt tension, check for proper pulley
alignment. This is especially critical with serpentine belts. Measure the belt
deflection in its longest span. If a belt tension
gauge is available, use it and compare the tension to
specifications.
”If a belt is too tight, wear to bearings for the water pump, alternator,
and engine crankshaft can result.”
11 Pry the idler or generator pulley to adjust the belt to
specifications.
12 Tighten the idler or generator pulley fastener.
13 Start the engine and check the belt for proper operation.
SOURCE: routing of serpentine belt for ford escort zx2
Click on the link below, Enter the year,make,model, and engine. You will get a page with a link to the diagram you need under the part number.
Greg
http://www.mvreader.com/multiview/dayco/index.php?autoCatalogSearch=0&catalog=auto&l=n&year=2000&year_from=&year_to=&make=FORD
SOURCE: belt routing diagram 98 zx2 2.0
1) Start with the alternator.
2) Forward to the smooth idler
3) Forward to power steering
4) Down to A/C compressor
5) Back to crank pulley
6) Forward around tensioner
7) Back glancing off of water pump
8) Back glancing off of ribbed idler
9) Up around alternator (where you started)
Good luck!
1,270 views
Usually answered in minutes!
×