SOURCE: Stalling Toyota Camry 2004
P-0102 and P-0113 are mass air flow and intake air temp codes, the P-0136 is an Oxygen sensor code. Before you do anything, check for debris in the Mass Air Flow Sensor, it's small black box with electrical wiring connector that is screwed into the intake air tube, between the air box and the intake manifold. Undo the screws, remove the sensor, and, with a flashlight, and look down inside it for debeis, or broken wires inside it. If it's dirty, it could throw a P-0136...Comment back on what you find; hope this helps, and thanks for choosing FixYa!
SOURCE: installing power window on 1993 toyota camry
Take the door panel off. Disconnect the window and tape it up. Remove the regulator out off the door cavity.
SOURCE: how do I change my 2002 Camry Alternator... The
I hope you disconnected the neg. battery cable.
SOURCE: replace alternator belt only for 1993 toyota camry
loosen the mounting bolts on the alternator, remove the old belt, replace with the new belt, slightly tighten the top mounting bolt, pull the alternator up until the belt is tight or if there is an adjustment bolt, crank down until tight (shouldn't bow more than 1"), and tigten other hardware.
67 views
Usually answered in minutes!
cut it off
×