-
Ford Expert
262 Answers
- Posted on May 12, 2010
Re: How do i change the coil
Ignition Coil
Removal
-
Disconnect fuel charging wiring connectors from ignition coil (12029) and radio ignition interference capacitor (18801) .
-
Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
-
Remove four ignition coil retaining screws and remove ignition coil and radio ignition interference capacitor . Save radio ignition interference capacitor for installation with ignition coil .
Installation
-
Position ignition coil and radio ignition interference capacitor to ignition coil mounting bracket.
-
Install retaining screws and tighten to 4.5-7.0 Nm (40-61 lb-in).
-
Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all ignition wire boots.
-
Install each ignition wire connector to the proper terminal on the ignition coil . Make sure boots are fully seated.
-
Connect fuel charging wiring (9D930) to the ignition coil and radio ignition interference capacitor .
×