MY REAR SEAT BELT IS STUCK AND WONT PULL OUT AT ALL.

First off, are you able to move the seat forward, backward, or upward to free up the tension on the seat belt lock so you can again pull out slack? If not, are you able to raise or remove the headrest to create slack in the seatbelt and release the lock? Without a photo of the situation it's difficult to understand how you managed to get a seatbelt stuck around a headrest....

I think the seat belt have a twist and it went into the seat belt housing. Pull the seat belt all the way out hard and un do the twist and let it go back into the seat belt housing. This should fix this problem

Not an easy task. You likely have one of 2 problems. If center seat belt is in the seat that is down, it may be locked. If so, you need to remove the seat back cover then the seat belt retractor. You can then position the seat belt retractor upright (how it sits when the seat is up) and pull the seat belt out making slack to raise the seat. This only happens if the either the stop on the seat belt is broken or the seat belt guide on the seat back is broken. If that's not the problem, you likely have a release cable that has come loose under the seat. If you look at the half that works, you can determine what you need to move on the locked seat and try to get to it with a long tin screwdriver or similar implement.

try spraying wd 40 into the locking slit may loosen what ever is sticking if not may have to unbolt the belt at the anchor point , follow the piece of belt ,either under seat or on side panel good luck

the camry does NOT have the type of belt you require.only answer is replacements or change the child seat to one that fits the anchorages.

Remove the panels to the belt, normally these can miss roll and get stuck. Unbolt the unit so you can get some slack that should be enough to release and pull it back out to correct it. If that will not do it get a replacement from a junkyard and replace.

since it's a safety item it's highly recommend against any type of service.. if you can get the assembly out from behind the trim panel or under the back seat if it's the rear...remove the side that has the belt wound up and the gear showing. More then likely the pin and weight have gotten caught in place and the belt tightened up without any slack to let the pin release. this pin falls into place when the brakes are applied and inertia set the pin in place to stop the seat belt from unwinding. wind the belt in the tightening direction, pull pin out of gear mechanism and reinstall....best bet would be buy new

This happens to me also. To solve the problem you need to un-bolt the seat belt clip. A bit tricky when the bench is tight down, but get a friend to hold it up out of the way as much as possible. This will relieve the tension and allow the seat belt to return to normal. To prevent this in future, pull the seat belt out and clip it in to place before lowering the back bench. This allows enough slack on the seat belt tensioner to stop the problem from happening again.

anyone have answer for this problem??? i have 05 grand cherokee with same issue.