1999 Ford Taurus Logo

Related Topics:

Posted on Apr 30, 2010

NO HEAT WHEN HEATIS TURNED ON - 1999 Ford Taurus

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 5 Answers
  • Posted on May 01, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

Joined: Apr 13, 2010
Answers
5
Questions
4
Helped
974
Points
7

Make sure it is full of coolant if it is check ur hoses goin into heater core they r notorious for the heater core stopping up, if both hoses are hot you have a blend door actuator problem let me know what u find oh yeah if the heater core is stopped up ive found that takin one hose off and usin a steam pressure washer u can get most of that **** out

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

With heat turned off engine runs ok with heat turned on engine rpms are erratic

If defrost is on that means AC cycles to remove humidity. Does this also occur when ac is running set at very near outside temp so it cycles? Could be the throttle positioning sensor (TPS) acting up.
0helpful
1answer

Heat comes on all the time, even when ac turned on

resistor bad in wiring harness from switch to heater and ac.ford had a recall on that stuff but did;nt send notice. also check fuse
0helpful
1answer

2004 Hyundai Santa Fe burning smell when heat is turned to exhaust only...when turned to a different selection then no smell.

Need a good look sorry could be a foam seal is smelling ,honestly couldnt tell you so i would advise you ask a local mechanic to investigate
0helpful
1answer

Whistling noise from my Honda civic

Ok, whenever i turned on the heat in my 2009 Honda Accord, i hear a whistling noise, then i turned off the heat and it's gone. It only happens when the heat is on, help?
0helpful
1answer

Live in northern canada, vehicle only starts after direct heatis applied to starter. Is it possibly a solenoid or the ignition circuits? When milder weather, vehicle starts easily. Colder weather, will...

I would suspect the solenoid plunger is sticking due to some rust, dirt, moisture, or congealed oil. Remove the starter and clean the solenoid contacts, the spring, and the plunger with electrical contact cleaner. If this doesn't help, replace the starter/solenoid assembly.
2helpful
1answer

Heat always blowing on floorboard when driving even in off mode.

on the bottom of the heater case is a vaccum door right on top of the hump it has a white plastic adaptor that breaks replace with dealer part it just pops off
0helpful
1answer

Cannot get heat out of floor vents -only defrost and dash heat

i had a simmiler problem on my 95 chevy pick up. on mine it would not chg. from floor to defrost, no matter where i put the selector. with mine it was the controls. if you go under solutions for k1500chevy gmc trucks it should tell you what your problem is, or give you an idea whats going on with yours.
1helpful
1answer

NO HEAT BLOWS OUT WHEN I TURN MY HEAT ON

Is the car tempature gauge working ? Another words is the car operating at tempature? it could be just that your thermostat is stuck open and probably needs replaced
Not finding what you are looking for?

83 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...