I dont know in what order my spark plug wires hooked up.

what do you mean by dirty is it fuel fouled or oil?

Unless the wires were removed the firing order cannot change as also the length of the wires do not permit that the wires switch over.
All what is needed is to check the spark at each plug , if of low internsity check the ignition system including the HT coil. Also the fuel filter and the fuel pump for the right pressure.

Hello! I'll need the year, model and engine size of your Ford in order to answer your question...

Guru.....Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

pull off plug grabbing it as close to spark plug as you can. Using socket rotate counterclockwise and remove plug. Be careful putting plugs back in and thread by hand first. Then torque as plug box says as it depends on if you have a washer or not.

If u can't see the diagram go to the link, just match up the numbers on the coil to the engine cylinder numbers.

http://autorepair.about.com/library/firing_orders/bl-fo-5630.htm

look at the distributer and follow the spark plug wires from it out to each spark plug but each wire as u pull them. dont take all off at once . or u might not know how to hook them all back the right way.

fire order 1-4-3-2

find the firing order which is usually on the intake manifold,put the crankshaft on 0 degrees top dead center,pull off the distributor cap and mark where the rotor button is pointing,start #1 cylinder at that spot(which that spot should be pointing towards the rear of the distributor),and # 1 cylinder is front of engine on the drivers side then it goes next 1 back #3 then # 5,and the passengers side front is #2, then #4,then #6 towards the back,and the firing order goes clockwise on the distributor.if it spits and sputters or back fires,then the timing firing order is off 180 degrees,so move every wire to the exact opposite on the cap,so your #1 plug wire will be opposite from where you put it first.then double check the firing order and all plug wires then try it.the firing order is:165432,i still dont know how to send pictures.

If you pulled all the wires at once, you will need to go to a parts store and see if they can show you a diagram on how to reset the wires. Do not unhook the wires from the spark plugs at this point.

Not sure what you're asking. The only order that matters is the order of the spark plug wires. There isn't an order for the spark plugs themselves. So are u looking for the order of the spark plug wires?