The engine of the car origanally Jerked while on the run,later it started to stop suddenly ,after you rest for a about 20 to 30 minutes it will start,
but now it starts & stops within few seconds,right now it wont start at all.
SOURCE: how to take out and reinstall new axle on 1996 toyota corolla,
1. Jack up and support car on jack stand. Make sure to chock wheels and or lock the parking brake on.
2. Remove wheel
3. Remove cotter key, castle lock and nut at center of rotor that attaches the axle. - If you lack and impact gun to remove this - it is easier to loosen this nut with all of the wheels on the ground.
4. Remove outer tie rod from spindle, Tap out with hammer. Should not require much force.
5. Remove the single bolt from the lower ball joint and separate from spindle.
6. Pull axle out of spindle and remove from transmission. This may require you to drive this out with a hammer and punch ( I use a brass punch), make sure not to damage threads if you intend to reuse the axle.
To install reverse the procedure. Make sure to replace any cotter key removed with new ones during install.
Torque specs you need are
Ball Joint to Spindle = 91 ftlbs
Tie rod to spindle = 36 ftlbs
Drive axle hub nut = 166 ftlbs
SOURCE: car aircon
try adjusting the thermostat of the A/C , that is one of the main reason of the change of condition...
reply if it will do the same thing
532 views
Usually answered in minutes!
×