-
Buick Master
17,989 Answers
- Posted on Apr 12, 2010
Re: Where is the fuel filter located
Fuel Filter - Removal & Installation
-
Before servicing the vehicle, refer to the Precautions section.
-
Disconnect the negative battery cable.
-
Relieve the fuel system pressure.
-
Twist the quick connector
1
/
4
turn in each direction to loosen any dirt that may have
accumulated in the connector.
-
Use compressed air to remove any dirt in the connector.
-
Squeeze the plastic tabs of the male connector and pull apart.
-
Remove threaded connection from the filter inlet.
-
Remove the filter.
To install:
-
Position the fuel filter, making sure it is facing in the proper
direction.
-
Attach the outlet quick connect line to the fuel filter as
follows:
-
Step 1: Be sure the connector is clean and that a new plastic
retainer is used on the filter.
-
Step 2: Apply a couple of drops of engine oil to the male pipe end
of filter.
-
Step 3: Push the fuel line onto the fuel filter until the plastic
retainer snaps into place.
-
Step 4: Check that the connector is locked into place by trying to
pull the connector from the filter.
-
Install the threaded connection to the inlet side of filter and
tighten to 22 ft. lbs. (30 Nm).
-
Connect the negative battery cable.
-
Pressurize the fuel system by turning the ignition switch to
the
ON
position for 2 seconds. Turn OFF the ignition switch for 10
seconds. Turn ON the ignition switch. Check for fuel leaks.
Good luck (remember rated this).
×