View of mark for timing belt.

Hi from uk the cambelt/timing belt comes as a kit ie timing belt and tensioner cost £50 here in uk ? it is not too difficult diy job approx 2hours the engine must 1st be set to TDC number 1 firing then at this setting the cam cog mark is a hole drilling in the web of cog and should line up at 12 oclock upwards and using a mirror look thro drill hole and you will see a vertical notch/groove behind on font engineface this is correct mark the crank cog mark lines up with aother mark on engine front face at approx 12 30 pm oclock ? if now set you slacken tensioner bolts and push t/pully away to left from belt ? then remove belt next remove complete tensioner assy after undoing bolts then fit new tensioner push t/pully to left from belt run and lock bolt/s recheck t/marks then fit new belt from c/shaft in anticlockwise rotation when fitted release tensioner bolt and allow to tension belt push t/pully onto belt and lock up tensioner bolts20=27 Nm rotate engine manually for four turns then recheck marks ? should still aligne then re assemble torque crank bolt to =140-150 Nm A LITTLE HINT ? b4 you remove the water pump belt ? slacken thefour 10 mm headed bolts (spanner size) that secure w/pump pully to pump it will be easier to halt rotation of pully if you holt belt tight by hand this pully has to come off to remove c/belt covers same for power steer belt which is also driven from the w/pump pully the power steer pump slide adjuster has a 12 mm bolt you slacken and best done with open end spanner ? after slackening the pump mounting bolts/nuts underneath pump hope you can follow this info/tips wish you good luck from uk