Replacing brake light on a subaru outback limited wagon 2000

One filter is pointed up vertically near the power brake booster,
the other is easy to see and replace when you remove the left rear
wheel, at the front inside of the wheelwell.

Knowledgeable mechanic should do it 15 minutes.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

did you replace the upper strut mounts? it is a good idea to get new ones when you do the struts.

Thanks for choosing FixYa and welcome to the sight. You should be able to get to it from the trunk. You will need to remove the carpet on the inside wall to get to the bulbs.

The bulb in our 2005 Outback dome light has been replaced twice---I found the best way to remove the cover is with a dime.

Good luck!

How To Replace Do a Front Disc Brake Job 2000-04 Subaru Outback

remove lower cover, remove cover on back of lamp and disconnect wire then unhook clip (clip just swings to the side) and remove bulb. dont touch new bulb on the glass part ,will weakin life of lamp. goodluck.

In order to replace the bulb you need to remove the pad from the inside the car where the light located ,once you remove the pad you able to reach the light holder replace the bulb fix the pad the again ...

Good luck ....

all you need to do is remove the clip holding the washer fluid neck filler, once this is out of the way you can access the big gray backing that should have two wires coming out of it. just twist in the direction indicated and remove the cap, now you have access to the back of the bulb, remove the wires attatched to it and remove the metal clip that holds the bulb in place. now just put the new one in. You will see a small tab on the round part of the bulb, below the glass, align it right in the slot and put the metal clip back on and put the wires back on and backing cap and washer filler cap. P.S do not touch the glass on the new bulb, the grease on your fingers will prematurely burn the bulb out.

No, you just remove the radiator grill and the side marker light and the headlight housing bolts and it comes out. Not a real hard job and is Real straight forward. Good luck and have a good day.