I have a problem with an 1988 ford crown victoria ltd its the fuel gage it doesnt work when u put gas it stays on E can some 1 please help me with this problem. thanks

If you have a working fuel pump,you
obviously have a working relay turning it on

Make: FORD
Model: LTD CROWN VICTORIA
Year: 1991
Engine: V8 - 5.0L - FI - - GAS

part Number: RS14LC
GAP: .050" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Hope this helps (remember to rate this answer).

the float on the fuel pump is frozen, you need to drop your fuel tank and take out your fuel pump and move the float back and forth till it goes on its on with ease. please call 419 689 1114 for futher help thank you

charges apply

Take out the sender from the tank and clean it. If it's too corroded buy a new one. If you can't find a new one you will have to buy one from a scrapyard or adapt an older Ford one .

sounds like your having transmission problems. check fluid first if that doesnt help have it checke out

i am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount?

Check they float in the gas tank. From what I've been gathering they tend to go pretty easily.

Check the inertia fuel switch located near the floorboard. It will have a button that you can press to reset the switch.

when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC