You most likely have a broken wire under your steering wheel horn push housing and it's grounding itself during rotation of steering wheel , it may also be a spring broken on the horn push assy and the columb assy may be worth a peep . Good luck
SOURCE: horn wont blow
the problem is the rotating contact that connects the horn to the steering column wiring harness, this part is called the clock-spring contact, u must remove the steering wheel to change the part out.
SOURCE: 1997 Neon Horn Will Not Work
Did you look up under front facia in front of radiator, in center support area? I wouldn't be pulling wheel until I found horn first. Make sure you disconnect battery before, if you do.
SOURCE: Horn blows when steering wheel is turned. Is is a short?
this is caused by a defective/shorted rotating ribbon contact under the steering wheel called a clock spring, to replace this part u must disarm the airbag remove it and the steering wheel and then replace the clock spring, this is a dealer only part.
SOURCE: steering wheel horn button not working 98 gulf
you need to find the wire connected to the horn of the vehicle and follow it back to through the firewall and make sure that it is connected to the horn itself. If not you will need to run another one. Also check the fuses
SOURCE: 1986 chevy c10 truck. pulled steering wheel to
THE horn piece should turn with the wheel lock plate. if it does not then something is not installed properly
501 views
Usually answered in minutes!
×