How do i change front wheel bearing on a ford focus st2

SECTION 204-01: Front Suspension 2000 Focus Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 03/18/2003 Wheel Bearing
Special Tool(s) Installer, Wheel Hub Bearing Cup
204-023 (T73T-1217-A) Remover/Installer, Bushinhow do i change front wheel bearing - 15064.jpg04-180 (T93P-5493-A) 205-140 (T80T-4000-F) Adapter for 303-224 (Handle)
205-1how do i change front wheel bearing - 21217.jpg4000-W) Puller, Bearing
205-D064 (D84L-1123-A) Installer, Wheel Speed Sensor Ring
206-054 (T93P-20202-A) Removal

1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle in this section.

1. NOTE: When removing the hub from the wheel knuckle the bearing will be destroyed. The bearing inner rhow do i change front wheel bearing - e0027601.jpgon the hub and the bearing outer ring will be in the wheel how do i change front wheel bearing - ani_caut.gif/>Using the special tools, remove the wheel hub from the wheel knuckle.

1. CAUTION: The special tools must be used to prevent damage to the hub. If the hub is how do i change front wheel bearing - e0027602.jpgw hub must be installed.
   CAUTION: Dohow do i change front wheel bearing - e0002134.jpgt to remove the bearing inner ring.
   Using the special tools, remove the bearing inner ring from the wheel hub.

1. Remove the circlip from the wheel knuckle.

1. Install the old bearing inner ring.
   1. Install the bearing cage and inner ring assembly to the wheel knuckle.

Using the special tools, remove the bearing outer ring from the wheel knuckle.

CAUTION: Avoid any impact on the wheel speed sensor ring.

CAUTION: Make sure the wheel speedhow do i change front wheel bearing - e0027604.jpg is clean.

CAUTION: Avoid any contact between the wheel speed sensor ring and a magnetic surface.

CAUTION: Make sure the wheel bearing is installed into the wheel knhow do i change front wheel bearing - e0027605.jpghe wheel speed sensor ring, colored black, at the wheel speed sensor end of the wheel knuckle.
Using the special tools, install the new wheel bearing to the wheel knuckle.

1. NOTE: Make sure the circlip does not cover the wheel speed sensor.
   Install the circlip to the wheel knuckle.

1. Using the special tools, install the wheel hub to the wheel knuckle.

1. Install the wheel knuckle. For additional information, refer to Wheel Knuckle in this section.