I'm putting a new radio in a Hyundai 2005 Tucson and need instructions to remove and re-assemble the dash

Question edited for clarity and add maker.

It is normally a blown fuse or bulb for the SRS light or a wiring fault to the SRS light. It will most likely be a blown SRSD bulb or wiring problem, you will need to remove the instrument cluster and dismantle it to check the bulb.
Aug 10, 2023

I have a 2005 Hyundai Tucson and the airbag light is on. I

More here and videos

https://www.google.com/search?q=2005+Hyundai+Tucson+airbag+light+on

..

The fuse is in the engine compartment fuse box and is marked 'A/Con'. It looks like a Relay to me and as it doesn't have an amperage, my guess is that it is a relay. The different sites have slightly different variations, but the thing to check first is the relay. You mention 'heater coil', that is on the engine coolant circuit and only provides hot air. The AC compressor system has an 'evaporator' up in the dash and only supplies chilled air. I trust the AC job was done professionally with a Gas Recovery machine to create a moisture free vacuum before adding refrigerant gas. It can't be done at home. I wrote a Fixya Tip on it.

Hyundai Tucson (JM; 2004-2009) fuses and relays

Fuse Box Diagrams https://fuse-box.info > hyundai > hyundai-tucson-jm-2...

Here you will find fuse box diagrams of Hyundai Tucson 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside ...

2005 Hyundai Tucson fuse box diagram

StartMyCar https://www.startmycar.com > Tucson > Fuse box

2005 Hyundai Tucson fuse box diagram. The 2005 Hyundai Tucson has 2 different fuse boxes: Engine Compartment diagram. Inner Panel diagram.

Hyundai Tucson 1 (ix35) - fuse and relay

FuseAndRelay.com https://fuseandrelay.com > hyundai > tucson-1

It is located in the left end of the dashboard, behind the protective cover. ... The fuses designated as C / LIGHTER or P / OUTLET are responsible for the ...
https://www.google.com/search?q=2005+hyundai+tucson+ac+relay+location

..

Hi,

Please check the heater motor and also the thermostat. If those don't work, then this can also lead to your ac/heating system to malfunction as well.

Please use autozone to get a free diagnostic run on your car to get a list of errors. Then, they can tell you which errors are relevant to your ac/heating issue.

Thank you.

Search Results

2005 Hyundai Tucson Recalls - Cars.com

www.cars.com/recalls/hyundai/tucson/2005/

Cars.comLook up all NHTSA vehicle safety recalls for your 2005 Hyundai Tucson, and contact a nearby service center for free repairs.

2005 Hyundai Tucson Problems, Defects & Complaints

www.carcomplaints.com/Hyundai/Tucson/2005/
7 days ago - The 2005 Hyundai Tucson has 199 problems & defects reported by ...January 11: Hyundai Genesis Recalled to Replace Dangerous Tires ...

Hyundai Tucson Recalls ' RepairPal

repairpal.com > Recalls > Hyundai
Other systems that may be affected include: cruise control, push-button start, gear shifter, and Electronic Stability Control (ESC) system. Dealers will replace the brake light switch to correct this concern. ... The stop lamp switch may fail, affecting many vehicle systems including ...

2005 Hyundai Tucson Recall - Learn About Recalls for 2005 ...

www.automd.com > Recalls and TSBs > Hyundai Recall > Tucson

If your model has 4wd, the computer decides when it is needed.
There should be a button on the dash that will allow you to lock it into 4wd up to 30 mph.

Try choke start. Check wiring to spark plug. And clean gap between spark plug contact points.

14765

You don't remove the dash... you remove the VERTICAL Console.

Jack the front of the car up, and make sure it is securely supported. Remove the wheel, remove the 2 guide bolts (located on the back of the caliper), and remove the caliper, hanging it by a coat hanger or wire to keep pressure off the brake line. Remove the pads and shims. Clean rotor with brake parts cleaner, and install new pads/shims. Repeat on other isde. Check with the parts store to see whether or not you need to use anti-squeak compound for your specific brake pads. Once you install them, you will need to bed the brakes to get the most use out of them. Accelerate to 30mph, then hard brake to zero (5-10 times), then repeat but to 60mph and hard brake to zero. Do this a couple times, and you will get very long life out of your brakes.