Question about 2008 Chevrolet Impala
The Cabin air filter is located under the cowl on the passenger side (below the bottom of the windshield). There is just one push type retainer in the outside corner of the cowl the needs to be pulled out and the cowl cn be pulled up just far enough to remove and install the cabin air filter, which just slides in and out.
Posted on Jan 19, 2011
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.
Posted on Apr 01, 2010
Tips for a great answer:
Feb 05, 2016 | 2006 Chevrolet Chevrolet Malibu
Oct 17, 2014 | 2008 Chevrolet Malibu
May 22, 2013 | 2005 Chevrolet Impala
Jun 05, 2011 | 2008 Volkswagen Beetle
Oct 21, 2010 | 2003 Chevrolet Impala
Mar 13, 2010 | 2008 Chevrolet Impala
Nov 22, 2008 | 2005 Chevrolet Impala
1,523 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: