Where is the air suspension lines on a Lincoln

Compressor may be bad.

There can be several reasons. The system will not activate unless all the door switches and the trunk switch indicate everything is closed. There are some fuses and Relays for the pump motor that can be checked. There is a cutoff switch in the trunk which is shut off for tire service and other things requiring lifting the vehicle.

Some of the better scanners can check the Air-lift system systems. You can call Autozone, Advance, or Oreilys to see if they have the better scanner to do this. Usually free at these brands.

CHECK AIR SPRINGS SOLENOID O- RINGS FOR LEAKS.LISTEN FOR AIR LEAKS AROUND EACH AIR SPRING. WHILE CAR ON GROUND. IF YOU SPOT A LEAK.TURN OFF AIR SUSPENSION OFF FIRST.THEN SAFELY RAISE VECHICLE.REPLACE ALL AIR SPRINGS SOLENOID O - RINGS BUT FIRST BLEED AIR OUT OF AIR SPRINGS FIRST BY REMOVING AIR SPRING SOLENOID CLIP THEN SLOWLY PULL AIR SPRING SOLENOID TO SECOND STOP DONT PULL ALL THE WAY OUT.TO SAFELY LOCK OUT VECHICLE REMOVE NEGATIVE BATTERY CABLE TO KEEP AIR COMPRESSOR FROM TURNING ON.YOU DONT WANT AIR IN SPRINGS WITH VECHICLE IN THE AIR. DONT TRY REMOVE AIR SPRING UNTIL ALL THE AIR IS OUT.YOU NEED A FORD TESTER TO DO A FUNCTIONAL TEST ON AIR SPRINGS.

Most likely the airbags have a leak in the bags themselves or the air lines they have conversion kits that switch to coil springs for about $250 bucks at Strutmaster.com. Or go to a junk yard and get some used bags and lines for about $50 bucks your choice. Good Luck

Add Freon.

go to strutmasters.com. thay offer air ride parts. but thay also offer a suspension conversion kit that does away with the costly air ride system. i have several customers that have converted thare vehicles with this kit and say thay cant tell the differance in ride and are verry satisfied

the air lines or bags need to be replaced,check the lines at the pump

Experienced problem after problem with my suspension on my 1990 LSC. Finally contacted "Strut Masters" online and replaced my entire system with a conversion for less than 400 and an afternoon. Installation was simple.

check to make sure all the self leveling shafts are mounted to ther sensors

sounds like the fuel pump or a wire is off for the fuel pump or maybe filter is plugged